Printronix SL5000r manual Installation

Page 13

Installation

Installation

AC Power

Receptacle

Power Switch

1.Place the printer on a flat level surface that allows easy access to all sides of the printer.

CAUTION Never operate the printer on its side or upside down.

2. Make sure the printer power switch is in the Off (O) position.

WARNING Failure to properly ground the printer may result in electric shock to the operator.

In compliance with international safety standards, this printer has been equipped with a three-pronged power cord. Do not use adapter plugs or remove the grounding prong from the cable plug. If an extension cord is required, ensure that a three-wire cable with a properly grounded plug is used.

3.Attach the AC power cord to the AC power receptacle in the back of the printer.

CAUTION Verify the required voltage on the printer’s model number label on the back of the printer.

4.Attach the AC power cord to a grounded (three prong) electrical outlet of the proper voltage.

13

Image 13

Contents Quick Setup Guide Page Page Definitions Software License AgreementTermination of License Agreement Canada Communication NoticesDeclaration Of Conformity CE Notice European UnionTrademark Acknowledgements Taiwan Lithium Battery WarningTable of Contents Table of Contents Unpacking The Printer Unpacking And Installing The PrinterRemoving The Internal Packing Material Unpacking And Installing The PrinterInstallation InstallationPower Switch Controls And IndicatorsControls And Indicators Control PanelLiquid Crystal JOB Select Key Control Panel KeysControl Panel Down Key in Menu mode Menu KeyLoading Media And Ribbon Loading Media And RibbonLoading Roll Media Loading Roll MediaMedia Roll Media Hanger Guide Media Width Media Damper Loading Roll Media Lower Media Sensor Fixed Guide Media Width Notch Loading Ribbon Loading Ribbon Loading Media And Ribbon Printhead Pressure Adjustment Printing AdjustmentsPrinthead Pressure Block Adjustments Left Pressure BlockPositioning The Media Sensors Printing AdjustmentsFeed Positioning The Media SensorsRunning Auto Calibrate Calibrating The PrinterCalibrating The Printer Running Auto Calibrate Making a Media Profile Printout Making a Media Profile Printout Gap Sensing255 191 127 Advanced Gap Sensing Paper Out075 Changing The Active IGP Emulation Configuring The PrinterQuick Setup Menu Quick Setup MenuCont. from previous Print Mode Quick Setup Menu ItemsPrint Intensity Print SpeedMedia Handling Quick Setup Menu ItemsLabel Length Paper Feed ShiftLabel Width Ver Image ShiftOrientation Hor Image ShiftEdgetopTheof isimagethe thetoparallelleft theofedgemedia Quick Setup Menu Items Gap Sensing for Smart Labels Gap/Mark SensorAuto Calibrate Validator Funct Save ConfigActive IGP Emul SMT Status Power-Up ConfigSMT Sel Toolset SMT Select ToolAuto Save Configuration Saving The ConfigurationSaving The Configuration Loading a Saved Configuration Selecting The Power-Up ConfigurationPrinting a Configuration Printing a ConfigurationRun a Barcode Demo Test General Cleaning CleaningCleaning The Printhead, Platen Roller, Media Sensors ExteriorMedia Sensor Cleaning Platen Roller CleaningMedia Damper Cleaning Cleaning The Printhead, Platen Roller, And Media SensorsCleaning Upper Media Sensor From Printhead Heating Elements Repacking The Printer Repacking The PrinterMedia Cover window side Straps not supplied Printronix Customer Support Center Contact InformationPrintronix Supplies Department Contact InformationCorporate Offices For More InformationCorporate Offices Page Page 178423-001