Ultimate Technology 500 POS manual Local Mode Programming Function Codes and Default Settings

Table 2. Local Mode Programming Function Codes and Default Settings

71	Enable/Disable Key Clicks	On	Enables or disables audible key clicks.
			0 = off; 1 = on
80	Define Left Shift Key	Key 44	If auxiliary keyboard connected to the Series
		See	500 Keyboard is other than a standard 101 or
		illustration in	102- key keyboard, used to define where the
		Appendix D	AUX keyboard SHIFT keys are located. Refer
			to Appendix D.
81	Define Right Shift Key	Key 57 See	Same as Function Code 80 above.
		illustration in
		Appendix D
82	Define Left Control Key	Key 58	If auxiliary keyboard connected to the Series
		See	500 Keyboard is other than a standard 101 or
		illustration in	102-key keyboard, used to define where the
		Appendix D	AUX keyboard CONTROL keys are located.
			Refer to Appendix D.
83	Define Right Control Key	Key 64	Same as Function Code 82 above.
		See
		illustration in
		Appendix D
84	Define Left Alternate Key	Key 60	If auxiliary keyboard connected to the Series
		See	500 Keyboard is other than a standard 101 or
		illustration in	102-key keyboard, used to define where the
		Appendix D	AUX keyboard ALTERNATE keys are located.
			Refer to Appendix D.
85	Define Right Alternate Key	Key 62	Same as Function Code 84 above.
		See
		illustration in
		Appendix D
86	Programming Mode Enter Macro	None	Reserved for future use.
87	Lock Mode Enter Macro	None	Reserved for future use.
90	Send System Log	None	Used to read the Series 500 Keyboard system
			log at the main port. For detailed information
			about retrieving the system log data, refer to
			the Maintenance Section of this manual.
91	Main Port Select	Port 0	Used to select either the main keyboard port
			or main RS232 port as the main
			communications port.
96	Set Secure Mode	None	Used to toggle between secure or unsecure
			mode.
97	Default Keyboard	None	Used to reset Series 500 Keyboard to all
			programmed default settings.
98	Download Keyboard	None	Once a Series 500 Keyboard has been
			programmed, the parameters can be copied
			(cloned) from the source keyboard to other
			keyboards. This feature saves time and
			reduces errors when programming more than

16