Ultimate Technology 500 POS manual LED 2 turns on

Table 3. Local Mode Programming Instructions - Continued

Note: *Default Settings

Function Code(s)	Operation		Normal Indication	Remarks
		p o s i t i o n k e y s w i t c h , m o v e s w i t c h o u t o f t h e A U X p o s i t i o n .
02	1.	While in programming mode, at the Series 500 Keyboard numeric
Copy Primary Key		keypad, enter Function Code 02.
Functions to
Secondary Key			LED (2) turns on.
Positions
	2.	At the Series 500 Keyboard, press the designated key to copy its
		primary function into the secondary position.
	3.	Repeat 2 for next key to be programmed
	4.	When completed, press ENTER.
			LED (2) turns off.
	5.	Program the next function code or exit programming mode by entering 99
		on Series 500 Keyboard numeric keypad or by swiping the Programmer's
		card. If using the optional 3-position keyswitch, move switch out of the
		AUX position.
		Note: A Sec Op Key or Sec Op Lock Key must be programmed in the
		primary function mode in order to use secondary function codes.
08	1.	While in programming mode, at the Series 500 Keyboard numeric
Enable /Disable		keypad, enter Function code 08.
Magnetic Stripe
Reader (MSR)			LED (2) turns on.
Tracks

2.At the Series 500 Keyboard numeric keypad, enter the applicable number (1 through 6) to select the MSR track configuration per list below.

1 = Channel 1 enabled

2 = Channel 2 enabled

3 = Channel 3 enabled

4 = Channels 1 and 2 enabled*

5 = Channels 2 and 3 enabled

6 = All channels disabled

LED (2) turns off.

3.Program the nex t function code or exit the local programming mode by entering 99 on Series 500 Keyboard numeric keypad or by swiping the Programmer's card. If using the optional 3-position keyswitch, move switch out of the AUX position.

20