Ultimate Technology 500 POS manual 20 or

Table 3. Local Mode Programming Instructions - Continued

Note: *Default Settings

Function Code(s)	Operation		Normal Indication	Remarks
	4.	Program the next function code or exit programming mode by entering 99
		on Series 500 Keyboard numeric keypad or by swiping the
		Programmer's card. If using the optional 3-pos ition keyswitch, move
		switch out of the AUX position.
19	1.	While in programming mode, at the Series 500 Keyboard numeric keypad, enter
MSR Send		applicable Function Code 19.
			LED (2) turns on.
	2.	At the Series 500 Keyboard numeric keypad, enter the applicable number (0 or 1) per
		list below to select MSR data from one or both good tracks.
			0 = send any good track*
			1 = send only if all enabled tracks good
	3.	Program the next function code or exit programming mode by entering 99 on Series
		500 Keyboard numeric keypad or by swiping the Programmer's card. If using the
		optional 3-position keyswitch, move switch out of the AUX position.
20 or 30	1.	While in programming mode, at the Series 500 keyboard numeric keypad, enter
Comm (RS232)		Function Code 20 (Port 0) or 30 (Port 1).
Main Port 0 (20)
AUX Port 1 (30)			LED (2) turns on.
Baud Rate

2.At Series 500 Keyboard numeric keypad, enter the applicable number (1 through 9) to select baud rate per list below.

1 = 300		6	= 9600*
2	= 600	7 = 19200
3	= 1200	8	= 38400
4	= 2400	9	= 57600
5	= 4800

LED (2) turns off.

3.Program the next function code or exit programming mode by entering 99 on Series 500 Keyboard numeric keypad or by swiping the Programmer's card. If using the optional 3-position keyswitch, move switch out of the AUX position.

23