Ultimate Technology 500 POS manual

CAUTION

Replacement of the battery may result in the need to reprogram the keyboard. For programming instructions, refer to the programming section of this manual.

1.Disconnect keyboard from system.

2.Turn keyboard over to gain access to 5 screws that secure the base of the keyboard case to the top. Remove the 5 screws.

3.Turn keyboard upright. Gain access to the battery by lifting the top portion of the keyboard assembly from the base and placing it and the attached extended cable/connectors in front of the base.

4.Remove existing battery.

5.Making sure to observe correct polarity, install a new 3-volt lithium battery in the keyboard using one of the approved replacement batteries listed below, or an equivalent. Note that sweat and oil can prevent a battery's terminals from making electrical contact. To avoid this, wipe both sides before installing battery.

Panasonic, Part No. 884-0316

Eveready, Part No. 729-6010

Duracell, Part No. 737-0439

6.Make sure that the cable/connectors are making good contact, then position the top of the keyboard assembly on the keyboard base. Turn the keyboard over and secure top of the keyboard to the base by installing the 5 screws.

7.Connect keyboard to system.

8.Dispose of the used battery in an environmentally safe manner. If necessary, the battery may be returned to the Ultimate Technology Corporation at the address shown below for proper disposal.

Ultimate Technology Corporation

100 Rawson Road

Victor, NY 14564

60