Ultimate Technology 500 POS manual MNEMONIC/DESCRIPTION COMMAND/ACKNOWLEDGEMENT Code HEX

Table 5. Remote Programming Mode Commands - Continued

OP	MNEMONIC/DESCRIPTION	COMMAND/ACKNOWLEDGEMENT
CODE
(HEX)
A3	COMMP	COMMAND: A3Pbbbbbwsph<CR>
	Communications setup for	A3	= Op Code
	selecting ports, baud rate, word	P	= destination port for load
	length, stop bits, parity, and method	bbbbb	= baud rate
	of handshaking.	W	= word length 7 or 8 bits
		s	= number of stop bits 1 or 2
		p	= parity odd, even, or none
		h	= handshaking
		<CR>	= terminate command (0D hex)
		Port:	0 = main; 1 = AUX
		Baud rate:
			00300, 00600, 01200,
			02400, 04800, 09600,
			19200, 38400, 57600
		Word length:
			7 or 8
		Stop bits:
		Parity:	1 or 2
			O = odd, E = even, N = none
		Handshaking:
			H = CTS/RTS, S = XON/XOFF,
			B = both, N = none
		ACKNOWLEDGEMENT: NONE
A4	NOTES	COMMAND: A4xxxx-xxxx<CR>
	Used to enter up to 40 characters	A4	= Op Code
	of notes into RAM. Useful for	xx	= Note (max of 40 Characters)
	recording keyboard version and	<CR>	= terminate command (0D hex)
	date, etc.
		ACKNOWLEDGEMENT: NONE

41