Trango Broadband TrangoLink-10 user manual Cabling and Weather Considerations

Page 24

Deployment & Installation

Installation

Standard Mounting

Alternative Mounting

U p / D o w n

T i l t

Up/Down Tilt

4 X M u s t B e l o o s e n e d f o r U p / D o w n T i lt

Figure 8: Mounting Articulation

Proper mounting of the radio includes consideration for grounding. Please note that if the radio is attached to a metal pole that is earth- grounded, no other grounding is necessary. If the radio is not earth-grounded via the mounting bracket, you must attach a grounding wire to the grounding stud on the back of the radio as in the adjacent diagram.

Figure 9: Grounding Example

Cabling and Weather Considerations

Shielded twisted pair Cat-5 cable is recommended for all installations. The shield within the Cat-5 cable does not need to be grounded if the radio itself is grounded. It is important to consider that most Cat-5 cable will deteriorate over time if exposed to the weather (especially direct sunlight). It is recommended that installers place all Cat-5 cables inside conduit. Plastic conduit is sufficient. If metal conduit is used, it is not necessary to use shielded Cat-5 cable.

Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0

page 20

Image 24
Contents TrangoLINK-10 Point to Point Wireless Ethernet Bridge Table of Contents Table of Figures Table of TablesWarranty Information PrefaceFCC Information Contents OverviewOperational Overview Ethernet and Serial PortsConnections and Power Getting StartedBasic Configuration Concepts and Tools Opmode ConceptSysinfo Command Line Interface TroubleshootingTelnet ip address of radio Type resetpassword Serial PortConfiguration This section you willSettings Remote Unit Configuration Screen Basic Diagnostics Master Unit’s System Information Set defaultopmode on off Ipconfig ip subnet gatewayCLI Command tftpd on off CLI Command set remoteid RU’s MACCLI Command freq ch pol Power setism max min dBmRfrxth ism Freq writechannel ch# freqSet defaultopmode onoff Remote Unit System InformationTftpd on off Sw 0 on off Sw 1 on offSw 2 on off Deployment & Installation Site SelectionSite survey Installation Channel PlanningMounting Hardware Mounting Hardware Assembly Cabling and Weather Considerations Standard Mounting Alternative MountingRU Installation and Antenna Alignment RU Antenna Alignment ProcedureLink Test Management RU ManagementObjects for Monitoring and Control RU Bandwidth MonitoringSnmp Setup Command Description RemarkSame as updateflash OFF Appendix B Specifications