Trango Broadband TrangoLink-10 user manual Preface, FCC Information, Warranty Information

Page 4

Preface

FCC Information

Preface

This manual covers the basic configuration and installation of the TrangoLINK-10 Wireless Broadband System, and applies to the following radio part numbers:

P5830S-MU

Master Unit with internal sectoral patch antenna

P5830S-RU

Remote Unit with internal patch antenna

Also available is the TrangoLINK-10-EXT, which does not include an internal antenna. The TrangoLINK-10-EXT consists of a P5830S-MU-EXT and a P5830S-RU-EXT, and must be used in conjunction with an FCC certified external antenna (sold separately). Instead of an internal antenna, the P5830S-RU-EXT has two Reverse Polarity SMA RF Connectors for the attachment of external antenna cables. Contact your sales person for more information regarding the “Professional Installation Guide.”

FCC Information

This device complies with Part 15 of the FCC Rules and Regulations. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with these instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in any particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of more of the following measures:

1)Reorient the antenna.

2)Increase the separation between the affected equipment and the unit.

3)Connect the affected equipment to a power outlet on a different circuit from that which the receiver is connected to.

4)Consult the dealer and/or experienced radio/TV technician for help.

FCC ID: NCYM5830SSU

FCC ID: NCYM5830SSUEXT

IMPORTANT NOTE:

Intentional or unintentional changes or modifications must not be made unless under the express consent of the party responsible for compliance. Any such modifications could void the user’s authority to operate the equipment and will void the manufacturer’s warranty. To comply with FCC RF exposure requirements, the following antenna installation and device operating configurations must be satisfied. The antenna for this unit must be fixed and mounted on outdoor permanent structures with a separation distance of at least two meters from all persons. Furthermore, it must not be co- located or operating in conjunction with any other antenna or transmitter.

Warranty Information

Radios from Trango Broadband Wireless are warranted for one year from date of purchase. Please see www.trangobroadband.com for a complete description of warranty coverage and limitations.

Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. D for F/W Ver. 1.1

page iv

Image 4
Contents TrangoLINK-10 Point to Point Wireless Ethernet Bridge Table of Contents Table of Figures Table of TablesPreface Warranty InformationFCC Information Contents OverviewOperational Overview Ethernet and Serial PortsConnections and Power Getting StartedBasic Configuration Concepts and Tools Opmode ConceptSysinfo Troubleshooting Command Line InterfaceTelnet ip address of radio Type resetpassword Serial PortConfiguration This section you willSettings Remote Unit Configuration Screen Basic Diagnostics Master Unit’s System Information Set defaultopmode on off Ipconfig ip subnet gatewayCLI Command tftpd on off CLI Command set remoteid RU’s MACCLI Command freq ch pol Power setism max min dBmRfrxth ism Freq writechannel ch# freqRemote Unit System Information Set defaultopmode onoffTftpd on off Sw 1 on off Sw 0 on offSw 2 on off Site Selection Deployment & InstallationSite survey Channel Planning InstallationMounting Hardware Mounting Hardware Assembly Cabling and Weather Considerations Standard Mounting Alternative MountingRU Installation and Antenna Alignment RU Antenna Alignment ProcedureLink Test Management RU ManagementObjects for Monitoring and Control RU Bandwidth MonitoringSnmp Setup Command Description RemarkSame as updateflash OFF Appendix B Specifications