Trango Broadband TrangoLink-10 user manual CLI Commnand opmode on off, Set defaultopmode on off

Configuration Basic Diagnostics

Table 1: Reference Table of Master Unit System Information Parameters

Parameter	Description	Associated Page and Notes
Hardware Version	Hardware version is factory-set and cannot be	Permanent with Hardware
	changed by user.
FPGA Version and	This parameter provides information about the	See website for latest FPGA firmware and
Checksum	current FPGA firmware loaded in the radio.	release notes.
Firmware Version	The Firmware version is the initial four	See website for latest firmware version and
	characters of this string. (i.e. 1p60 = 1.60 )	release notes.
Device ID	MAC address of the radio.	Permanent with hardware
Opmode	Current operation mode of the radio. “On”	Configuration page.
	indicates transmitting. “Off” indicates not	Note: in order to change the radio from
	transmitting.	Opmode “On” to Opmode “Off,” you must
		change the default Opmode to “Off,” and
		reboot the radio.
		CLI Commnand: opmode [<on off>]
Default Opmode	Determines the Opmode (“ON” or “OFF”) of the	Configuration page
	radio after reboot/power cycle. When the
	parameter is set to “ON,” the radio will progress	CLI Command:
	into Opmode “ON” automatically after	set defaultopmode [<on off>]
	reboot/power cycle. Note: If radio startup is
	interrupted within 30 seconds after reboot (by
	opening a Telnet session) the radio will remain
	in Opmode “OFF.”
System Up Time	Time since radio was last rebooted or power	Informational Parameter
	cycled.
Radio Temperature	Current internal temperature of radio.	Informational Parameter
[IP]	IP, subnet, and Gateway address of radio used to	Configuration page
[subnet]	manage the radio.	Note: Changing the IP of the radio could
[gateway]		cause loss of management connectivity.
		CLI Command:
		ipconfig[< ip> <subnet> <gateway>]
Telnet Port	User changeable telnet port of radio.	Configuration page
TFTPD status	TFTP daemon status (on or off). TFTPD should	Configuration page
	be turned on to import a file (such as new	Note: TFTPD ON is used in firmware
	firmware) into radio’s TFTP buffer. Default is	upgrade process.
	off.	CLI Command: tftpd [<on off>]
Remote ID	MAC address of the Remote Unit	Configuration page
		CLI Command: set remoteid <RU’s MAC>
Status	Status of Remote Unit: Connected (wireless	Informational Parameter
	link established), or Disconnected (wireless
	link not established).
RSSI	Relative Signal Strength Indicator. Displays	Informational Parameter
	signal strength received from the MU to the	CLI Command: rssi
	RU. A “?” indicates RU is not connected.
Downstream MIR	Master Unit to Remote Unit maximum	Advanced page
	information rate (in kbps).	CLI Command:
		set mir [<downstream kbps, 100..10000>
		<upstream kbps, 100..10000>]
Upstream MIR	Remote Unit to Master Unit maximum	Advanced page
	information rate (in kbps).	CLI Command:
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0		page 13