Telit Wireless Solutions GE863-QUAD, GE863-PY manual 11.2ADC Converter, Using ADC Converter

GE863-QUAD

GE863-PY

1vv0300715 Rev. 1 - 19/09/06

11.2ADC Converter

11.2.1Description

The GE863-QUAD / PY module provides 3 Analog to Digital Converters. The input lines are available on:

ADC_IN1 on BGA Ball #23 of the GE863-QUAD / PY module and on pin 19 of PL104 on EVK2 Board (CS1151).

ADC_IN2 on BGA Ball #74 of the GE863-QUAD / PY module and on pin 20 of PL104 on EVK2 Board (CS1151).

ADC_IN3 on BGA Ball #70 of the GE863-QUAD / PY module and on pin 21 of PL104 on EVK2 Board (CS1151).

The on board A/D is 11-bit converter. It is able to read a voltage level in the

range of 0÷2 volts applied on the ADC pin input, store and convert it into 11 bit word.

	Min	Max	Units
Input Voltage range	0	2	Volt
AD conversion	-	11	bits
Resolution	-	< 1	mV

11.2.2Using ADC Converter

An AT command is available to use the ADC function.

The command is AT#ADC=1,2

The read value is expressed in mV

Refer to SW user guide or to GE863-QUAD / PY AT commands specification for the full description of this function.

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 59 of 79