SOYO 6KB82440 manual Memory Configuration, Hardware Setup

Page 11

Hardware Setup

7

686 (PII) Ð 266 CPU Settings (4.0 x clock)

FLASH

BIOS

SW1

ON

1 2 3 4 5

Figure 2Ð1Ð2. CPU Jumper Settings

686 (PII) Ð 300 CPU Settings (4.5 x clock)

FLASH

BIOS

SW1

ON

1 2 3 4 5

Figure 2Ð1Ð3. CPU Jumper Settings

686 (PII) Ð 330 CPU Settings (5.0 x clock)

FLASH

BIOS

SW1

ON

1 2 3 4 5

Figure 2Ð1Ð4. CPU Jumper Settings

Memory Configuration

The mainboard supports four banks of 168-pin 3.3V EDO/SDRM Unbuffered DIMM. The mainboard supports from 8 to 512 Mbytes with no other restrictions on memory configurations. You can install DRAM in any combination without having to rely on a memory configuration table. Memory configuration is thus ÒTable-FreeÓ in any bank.

Image 11
Contents LX PCI Mainboard User’s Guide Technical Reference 6KBDisclaimer About This GuideCopyright Notice TrademarksTable of Contents Drivers Installation Guide Dimm Key FeaturesUnpacking the Mainboard Electrostatic Discharge PrecautionsÐ1. Mainboard Layout Mainboard Layout w/ Default SettingsOverheating and ensure system stability JP5 Cmos Clear Jumper JumpersSW1 Bus Fraction Core/Bus Ratio Select Jumper CPU Type ConfigurationHardware Setup Memory ConfigurationMulti I/O Port Addresses ConnectorsATX PW ATX Power Supply Connectors PS/2 Keyboard ConnectorSPK Speaker Connector PS/2 Mouse ConnectorIR IR Connector Keylock & Power LED ConnectorFDC Connector IDE1/IDE2 On-board Primary/Secondary IDE HDD ConnectorsCOM1/COM2 Connectors IDE LED IDE HDD LED ConnectorsJP44 Wake-On-LAN WOL Header FAN CPU Cooling Fan ConnectorStep Slot 1 Installation GuideATX PW ATX PW Step Non-boxed Pentium Golden Finger Top View of CPU Support Clip Bios Setup Standard Cmos Setup Halt On Floppy 3 ModeSupport Bios Features Setup Swap Floppy Boot SequenceBoot Up Num SettingDram 64MB PCI/VGAMA Wait State Chipset Features SetupAuto Configuration DelayCPU-TO-PCI IDE Sdram RAS-to-CAS Delay Sdram RAS PrechargeTemperature Temperature System Temp and CPU FAN1 Speed VcorePower Management Setup APM PNP/PCI Configuration Setup INT# Load Setup DefaultsPCI IRQ PCI IDE IRQECP/EPP Load Bios DefaultsROM PCI/ISA Bios Integrated Peripherals Award SOFTWARE, INC Integrated PeripheralsPCI Slot IDE 2nd Channel Uart 2 ModePIO IDE Secondary SlaveParallel Port EPP Type Onboard Printer ModeECP Mode Use DMA Onboard Parallel PortÒConfirm PasswordÓ Supervisor PasswordÒEnter PasswordÓ User Password Hard Disks ROM PCI/ISA Bios Cmos Setup UtilityIDE HDD Auto Detection Drivers Installation Guide Windows Cd /inst Tar xvf /tmp/trisco.tar Drivers Installation GuideOS/2 2.0 and Warp InstallMotherboard Layout CPU Jumper SettingsDefault I/O Settings Connectors and Jumper Settings