SOYO 6KB82440 manual Drivers Installation Guide, Cd /inst Tar xvf /tmp/trisco.tar

Page 43

Drivers Installation Guide

39

4)From root directory, type the following commands: mkdir/inst

cd /inst

tar xvf /tmp/trisco.tar.

(Note: there is a period at the end of the last command.)

5)Now, insert a blank diskette into the floppy drive A and type: tar cvf /dev/<your floppy drive A device name>.

(Note: there is a period at the end of the last command.) Your floppy drive A device name could be:

¥rfd096ds15,5.25 DSHD

¥rfd0135ds18 3.5 DSHD

¥rfd048ds9 5.25 DSDD

¥rfd0135ds9 3.5 DSDD

Now you have already made an installation diskette for the device driver.

Start the installation by typing: custom.

6)Select the ÒInstallÓ operation and then follow the guided steps. When prompted ÒDo you want to set the device configuration (y/n)Ó, answer ÒnÓ.

7)Reboot your SCO UNIX system.

SCO UNIX 5.0

1)Install SCO UNIX 5.0 using the default SCO IDE driver.

2)Reboot your SCO UNIX system

3)Insert Triones supplied diskette into the 3.5 inch floppy drive of your system. Use doscp command to copy the file TRISCO.TAR to your /tmp directory. for example, if you are using floppy drive A, type: doscp a:/scounix/trisco5.tar/tmp/trisco5.tar

Image 43
Contents LX PCI Mainboard User’s Guide Technical Reference 6KBDisclaimer About This GuideCopyright Notice TrademarksTable of Contents Drivers Installation Guide Dimm Key FeaturesUnpacking the Mainboard Electrostatic Discharge PrecautionsÐ1. Mainboard Layout Mainboard Layout w/ Default SettingsOverheating and ensure system stability JP5 Cmos Clear Jumper JumpersSW1 Bus Fraction Core/Bus Ratio Select Jumper CPU Type ConfigurationHardware Setup Memory ConfigurationMulti I/O Port Addresses ConnectorsATX PW ATX Power Supply Connectors PS/2 Keyboard ConnectorSPK Speaker Connector PS/2 Mouse ConnectorIR IR Connector Keylock & Power LED ConnectorFDC Connector IDE1/IDE2 On-board Primary/Secondary IDE HDD ConnectorsCOM1/COM2 Connectors IDE LED IDE HDD LED ConnectorsJP44 Wake-On-LAN WOL Header FAN CPU Cooling Fan ConnectorStep Slot 1 Installation GuideATX PW ATX PW Step Non-boxed Pentium Golden Finger Top View of CPU Support Clip Bios Setup Standard Cmos Setup Support Floppy 3 ModeHalt On Bios Features Setup Swap Floppy Boot SequenceBoot Up Num SettingDram 64MB PCI/VGAMA Wait State Chipset Features SetupAuto Configuration DelayCPU-TO-PCI IDE Sdram RAS-to-CAS Delay Sdram RAS PrechargeTemperature Temperature System Temp and CPU FAN1 Speed VcorePower Management Setup APM PNP/PCI Configuration Setup INT# Load Setup DefaultsPCI IRQ PCI IDE IRQECP/EPP Load Bios DefaultsROM PCI/ISA Bios Integrated Peripherals Award SOFTWARE, INC Integrated PeripheralsPCI Slot IDE 2nd Channel Uart 2 ModePIO IDE Secondary SlaveParallel Port EPP Type Onboard Printer ModeECP Mode Use DMA Onboard Parallel PortÒEnter PasswordÓ Supervisor PasswordÒConfirm PasswordÓ User Password IDE HDD Auto Detection ROM PCI/ISA Bios Cmos Setup UtilityHard Disks Drivers Installation Guide Windows Cd /inst Tar xvf /tmp/trisco.tar Drivers Installation GuideOS/2 2.0 and Warp InstallMotherboard Layout CPU Jumper SettingsDefault I/O Settings Connectors and Jumper Settings