SOYO 6KB82440 manual FAN CPU Cooling Fan Connector, JP44 Wake-On-LAN WOL Header

Page 15

Hardware Setup

11

FAN: CPU Cooling Fan Connector

This 3-pins connector provides 12V power for the CPU cooling fan which matches the pin assignment of this connector. If you enable the Suspend Mode function in BIOS setup, this fan will stop when the system is into the suspend mode.

CPU Cooling Fan

Connector

(Pin Assignment)

GND	12V	SENSOR
1	2	3

Note: Make sure the pin assignment of our CPU Cooling Fan is matched

with this connector before connecting it, otherwise, you may

damage either the mainboard or the cooling fan.

JP44 – Wake-On-LAN (WOL) Header

Attach a 3-pin connector from the LAN card which supports the Wake- On-LAN (WOL) function. This function lets users wake up the connected computer through the LAN card. (The cable should be included with the LAN card.)

JP44 Pin Assignment

1 5V

2 GND

3 SENSOR

Image 15

Contents LX PCI Mainboard User’s Guide Technical Reference 6KBDisclaimer About This GuideCopyright Notice TrademarksTable of Contents Drivers Installation Guide Dimm Key FeaturesUnpacking the Mainboard Electrostatic Discharge PrecautionsÐ1. Mainboard Layout Mainboard Layout w/ Default SettingsOverheating and ensure system stability JP5 Cmos Clear Jumper JumpersSW1 Bus Fraction Core/Bus Ratio Select Jumper CPU Type ConfigurationHardware Setup Memory ConfigurationMulti I/O Port Addresses ConnectorsATX PW ATX Power Supply Connectors PS/2 Keyboard ConnectorSPK Speaker Connector PS/2 Mouse ConnectorIR IR Connector Keylock & Power LED ConnectorFDC Connector IDE1/IDE2 On-board Primary/Secondary IDE HDD ConnectorsCOM1/COM2 Connectors IDE LED IDE HDD LED ConnectorsJP44 Wake-On-LAN WOL Header FAN CPU Cooling Fan ConnectorStep Slot 1 Installation GuideATX PW ATX PW Step Non-boxed Pentium Golden Finger Top View of CPU Support Clip Bios Setup Standard Cmos Setup Floppy 3 Mode SupportHalt On Bios Features Setup Swap Floppy Boot SequenceBoot Up Num SettingDram 64MB PCI/VGAMA Wait State Chipset Features SetupAuto Configuration DelayCPU-TO-PCI IDE Sdram RAS-to-CAS Delay Sdram RAS PrechargeTemperature Temperature System Temp and CPU FAN1 Speed VcorePower Management Setup APM PNP/PCI Configuration Setup INT# Load Setup DefaultsPCI IRQ PCI IDE IRQECP/EPP Load Bios DefaultsROM PCI/ISA Bios Integrated Peripherals Award SOFTWARE, INC Integrated PeripheralsPCI Slot IDE 2nd Channel Uart 2 ModePIO IDE Secondary SlaveParallel Port EPP Type Onboard Printer ModeECP Mode Use DMA Onboard Parallel PortSupervisor Password ÒEnter PasswordÓÒConfirm PasswordÓ User Password ROM PCI/ISA Bios Cmos Setup Utility IDE HDD Auto DetectionHard Disks Drivers Installation Guide Windows Cd /inst Tar xvf /tmp/trisco.tar Drivers Installation GuideOS/2 2.0 and Warp InstallMotherboard Layout CPU Jumper SettingsDefault I/O Settings Connectors and Jumper Settings