SOYO 6KB82440 manual IDE1/IDE2 On-board Primary/Secondary IDE HDD Connectors, COM1/COM2 Connectors

Page 14

10	Hardware Setup

IDE1/IDE2 – On-board Primary/Secondary IDE HDD Connectors

Attach on-board hard disk drives to these connectors.

COM1/COM2 Connectors

Connect COM1/COM2 devices to these connectors.

IDE LED – IDE HDD LED Connectors

Attach on-board IDE device LEDs to this connector. The LED lights when an IDE device is active.

FDC Connector

Attach floppy cable to this connector.

PRT – Parallel Port Connector

Attach parallel port cable to this connector.

USB1/USB2 – Universal Serial Bus Connector

Attach USB cable to these connectors for external USB device.

PWRBT – ATX Power Supply On/Off Switch Connector (Momentary Type)

Attach a two-pin switch to this connector for turning the ATX power supply on/off.

Image 14

Contents 6KB LX PCI Mainboard User’s Guide Technical ReferenceTrademarks About This GuideCopyright Notice DisclaimerTable of Contents Drivers Installation Guide Key Features DimmElectrostatic Discharge Precautions Unpacking the MainboardMainboard Layout w/ Default Settings Ð1. Mainboard LayoutOverheating and ensure system stability Jumpers JP5 Cmos Clear JumperCPU Type Configuration SW1 Bus Fraction Core/Bus Ratio Select JumperMemory Configuration Hardware SetupPS/2 Keyboard Connector ConnectorsATX PW ATX Power Supply Connectors Multi I/O Port AddressesKeylock & Power LED Connector PS/2 Mouse ConnectorIR IR Connector SPK Speaker ConnectorIDE LED IDE HDD LED Connectors IDE1/IDE2 On-board Primary/Secondary IDE HDD ConnectorsCOM1/COM2 Connectors FDC ConnectorFAN CPU Cooling Fan Connector JP44 Wake-On-LAN WOL HeaderSlot 1 Installation Guide StepATX PW ATX PW Step Non-boxed Pentium Golden Finger Top View of CPU Support Clip Bios Setup Standard Cmos Setup Halt On Floppy 3 ModeSupport Bios Features Setup Setting Boot SequenceBoot Up Num Swap FloppyPCI/VGA Dram 64MBDelay Chipset Features SetupAuto Configuration MA Wait StateCPU-TO-PCI IDE Temperature System Temp and CPU FAN1 Speed Vcore Delay Sdram RAS PrechargeTemperature Sdram RAS-to-CASPower Management Setup APM PNP/PCI Configuration Setup PCI IDE IRQ Load Setup DefaultsPCI IRQ INT#Integrated Peripherals Load Bios DefaultsROM PCI/ISA Bios Integrated Peripherals Award SOFTWARE, INC ECP/EPPIDE Secondary Slave Uart 2 ModePIO PCI Slot IDE 2nd ChannelOnboard Parallel Port Onboard Printer ModeECP Mode Use DMA Parallel Port EPP TypeÒConfirm PasswordÓ Supervisor PasswordÒEnter PasswordÓ User Password Hard Disks ROM PCI/ISA Bios Cmos Setup UtilityIDE HDD Auto Detection Drivers Installation Guide Windows Drivers Installation Guide Cd /inst Tar xvf /tmp/trisco.tarInstall OS/2 2.0 and WarpCPU Jumper Settings Motherboard LayoutConnectors and Jumper Settings Default I/O Settings