SOYO 6KB82440 manual Slot 1 Installation Guide, Step

Page 16

12	Hardware Setup

Slot 1 Installation Guide

This mainboard provides a non-boxed 686 (PII) CPU retention set to secure the CPU on this board. Follow the steps below to secure this type of CPU on to your motherboard.

Step 1:

Find the ATX PW and the Slot 1 on the board and set the board in the direction as follows before doing any installation.

ATX	Slot 1 (for Pentium II CPU)
PW

Install the 2 pairs of screws, as shown in the following figure, from the bottom of the motherboard upward onto the mainboard.

Image 16

Contents 6KB LX PCI Mainboard User’s Guide Technical ReferenceAbout This Guide Copyright NoticeTrademarks DisclaimerTable of Contents Drivers Installation Guide Key Features DimmElectrostatic Discharge Precautions Unpacking the MainboardMainboard Layout w/ Default Settings Ð1. Mainboard LayoutOverheating and ensure system stability Jumpers JP5 Cmos Clear JumperCPU Type Configuration SW1 Bus Fraction Core/Bus Ratio Select JumperMemory Configuration Hardware SetupConnectors ATX PW ATX Power Supply ConnectorsPS/2 Keyboard Connector Multi I/O Port AddressesPS/2 Mouse Connector IR IR ConnectorKeylock & Power LED Connector SPK Speaker ConnectorIDE1/IDE2 On-board Primary/Secondary IDE HDD Connectors COM1/COM2 ConnectorsIDE LED IDE HDD LED Connectors FDC ConnectorFAN CPU Cooling Fan Connector JP44 Wake-On-LAN WOL HeaderSlot 1 Installation Guide StepATX PW ATX PW Step Non-boxed Pentium Golden Finger Top View of CPU Support Clip Bios Setup Standard Cmos Setup Support Floppy 3 ModeHalt On Bios Features Setup Boot Sequence Boot Up NumSetting Swap FloppyPCI/VGA Dram 64MBChipset Features Setup Auto ConfigurationDelay MA Wait StateCPU-TO-PCI IDE Delay Sdram RAS Precharge TemperatureTemperature System Temp and CPU FAN1 Speed Vcore Sdram RAS-to-CASPower Management Setup APM PNP/PCI Configuration Setup Load Setup Defaults PCI IRQPCI IDE IRQ INT#Load Bios Defaults ROM PCI/ISA Bios Integrated Peripherals Award SOFTWARE, INCIntegrated Peripherals ECP/EPPUart 2 Mode PIOIDE Secondary Slave PCI Slot IDE 2nd ChannelOnboard Printer Mode ECP Mode Use DMAOnboard Parallel Port Parallel Port EPP TypeÒEnter PasswordÓ Supervisor PasswordÒConfirm PasswordÓ User Password IDE HDD Auto Detection ROM PCI/ISA Bios Cmos Setup UtilityHard Disks Drivers Installation Guide Windows Drivers Installation Guide Cd /inst Tar xvf /tmp/trisco.tarInstall OS/2 2.0 and WarpCPU Jumper Settings Motherboard LayoutConnectors and Jumper Settings Default I/O Settings