Tascam IF-FW, IF-DM owner manual Click Next

Page 13

8.

9.	Click “Next”

10.“Your new hardware is installed and ready to use” will appear in the lower right of the Windows desktop.

11.Your IF-FW/DM MKII is installed and ready to use.

12.Whenever the IF-FW/DM MKII is connected to your computer, the “Safely Remove Hardware” icon will appear

in the Windows Taskbar. If you need to disconnect the FireWire cable between the IF-FW/DM MKII and your computer, please be sure to use this first to stop the drivers from talking to the IF-FW/DM MKII card. Note you will need to stop and quit any audio programs first, or Windows will not be able to unload the drivers.

13

Image 13

Contents Teac Professional Division Table of Contents IF-FW/DM Mkii Control Panel Introduction FeaturesMidi port In and Out from the computer Macintosh System RequirementsWindows DM-24 not supportedDM-4800 Requirements TrademarksInstalling the IF-FW/DM Mkii InstallationMaking Connections Configuring the Computer Windows Continue Anyway Continue Anyway Click Next Page Cursor Navigation Mixer Control ScreenCard Status Detailed DescriptionStatus No Cable InputWindows WDM IF-FW/DM Mkii DAW SetupOutput Version InformationAudio Midi Cubase / NuendoSonar Logic Pro Digital Performer System Clocking Clock SettingsMaster Clock 96k & 88.2k OperationVarispeed pitch Mixer Outputs IF-FW/DM Mkii & DM-Mixer RoutingDM-3200 DM-4800 Mixer InputsDM-4800 Windows IF-FW/DM Mkii Control PanelStatus Panel Settings Panel Configuration PanelOther WDM ConfigurationsAssign WDM Channels Dialog Mac General TroubleshootingCheck cables Check that OS X identifies the device Cycle the PowerControl Panel Check Check Device ManagerCheck Plug-and-Play Detection Contacting Tascam Customer Support Optimize for speed to reduce audio problemsRemove unrelated software and drivers Appendix Safety Boot FeatureMultiple Card support FireWire Cable Length and Bus Power1394a FireWire 400 ports FireWire Chipset Compatibility1394b FireWire 800 ports Page Technical Specifications