Check Plug-and-Play Detection

2.Right click on My Computer, select “Properties” and left click this.

3.Select the Hardware Tab

4.Click the Device Manager

5.In the list under “Sound, video and game controllers”, there should be an entry for “TASCAM IF-FW/DM mkII”.

6.If this entry is not there, or if there is a yellow “!” mark against it, uninstall and re-install the drivers. Do not attempt to use the “Update drivers” option from here.

7.If there is a Red “X” mark against the entry, the device has been disabled. Right click on the entry and select “Enable”

8.Also check that there is no Red “X” against your FireWire interface, by checking under “IEEE 1394 Bus host controllers” in this same list.

1.When the IF-FW/DM MKII is correctly detected by Windows XP, the plug-and-play icon will be shown in the far right of the task bar.

2.Left Clicking on this will show “Safely Remove TASCAM IF-FW/DM MKII”.

3.If there is no IF-FW/DM MKII in the list, re-install the drivers as described elsewhere in this manual.

Control Panel Check

1.From the Start Menu, select TASCAM->IFFWDMmkII- >IFFWDMmkII Control Panel

2.If this entry is not in the menu, reinstall the drivers, using the default installation directories and paths.

3.In the Control Panel, if the Device shows “No Device Found” and the previous check is OK, the firmware in the card may be incompatible with the version of the driver you are using. Update to the latest driver and firmware from www.tascam.com