Illegal FS The Mixer specified an unsupported sampling frequency. Since the IF-FW/DM MKII supports all of the sampling frequencies that the DM-3200 and DM- 4800 supports, this might indicate a hardware problem.
No Cable | There is no physical connection |
being detected between the IF-FW/DM MKII and the |
computer, the cable is likely to be unplugged at one end.
Driver Offline The IF-FW/DM MKII is connected physically to the computer, but no compatible driver is available.
Driver Not Locked The IF-FW/DM MKII is connected to the computer, but the driver is not providing data at the correct rate for stable audio, or the mixer’s Sampling Rate is outside the usable range. If the FS is correct and this condition persists, restart your computer.
FS Mismatch The IF-FW/DM MKII is connected to the computer, but the driver is not providing data at the same sampling frequency as the mixer. Your DAW project is probably set to use a different FS than the mixer is currently set to.
Not Ready The IF-FW/DM MKII hardware is not ready to start FireWire Audio transfer.
Input
This allows restricting the number of channels coming from the computer to 16 for reduced host load, or setting the full channel count of 32. Especially at high sampling rates, if you don’t need the full 32 channel count from the computer to the mixer for a project, you will get better performance from your computer by setting this to 16.
(Note) Before changing this setting, be sure that no audio applications are running, and no sound is being played back through the IF-FW/DM MKII. After changing the setting, wait a few seconds for the driver and OS to reconfigure to the new setting before re-launching your audio application.