Installing the Library
This chapter provides detailed information for installing the library hardware. For basic library cabling instructions, refer to the Quick Installation Guide.
Remove the Transport Locking Screws
To protect the library during transport, four transport locking screws hold the robotics in a locked position. The screws are marked with red plastic tabs protruding between the magazines and the front panel.
Caution | The transport locking screws must be removed before the StorageLibrary can | |
operate normally. | ||
| ||
Figure 3. Transport Locking Screws Marked with Red Plastic Tabs |
The transport locking screws will be detected when the StorageLibrary is powered on. To remove the screws follow the instructions below:
1Connect the power cord to the power connector on the rear of the library.
2Turn on the power switch on the rear of the library.
3The library detects that the transport locking screws are present. Follow the instructions on the front panel display to remove the magazines to get access to the screws. Remove the screws and reinsert the magazines.
StorageLibrary Installation and User Guide | 11 |