Figure 8. Mounting the Rack mounting Kit to a Rack
Rear Rack Mount Rail
Step 5
(Screw M6x12)
1
Step 3
(Screw M4x12, nut and washer)
Use these holes if rack depth is equal
or longer than the
StorageLibrary T40Step 1 Holes to be used if rack
depth is shorter than the StorageLibrary T40
Front Rack Mount Rail
Step 2
Step 5
(Screw M6x12)
Figure 9. StorageLibrary Mounted in a Rack shows the rails mounted in a rack with one screw M6x12 in upper hole on both left and right side. On the rear side, two screws must be used on both left and right side. A total of six screws are used to install the rails to the rack.
Mounting the StorageLibrary to the Rack
Make sure that the screws connecting the rails to the rack are tightened properly before installing the StorageLibrary in the rack.
Slide the StorageLibrary on the rails from the front of the rack.
Fix the StorageLibrary using two M6x12 screws in front of the rack, one on both left and right side. The lower screw on each side connects the library to the rack, whereas the upper screw on each side connects the left and right rail assemblies to the rack, as shown in Figure 9. StorageLibrary Mounted in a Rack.
Figure 9. StorageLibrary Mounted in a Rack, Front View
StorageLibrary Installation and User Guide | 15 |