Searching a Trunked Bank
If programming a Type I system, you cannot Scan the trunking bank you just programmed unless you enter talk groups into memory. See ahead for details. With the search function, you’ll be able to find all the active talk groups within the trunked system.
Once the data
channel is acquired, the scanner begins trunk tracking. Talk
group ID’s, which represent different service groups, begin to display.
While searching, you won’t know exactly who the ID’s are assigned to unless you listen awhile or until ID lists are available in frequency guides or on internet sites. However, it usually only takes a few minutes to figure out police, fire, and emergency medical personnel. Other IDs may take some time, but determining who each ID represents is half the fun of TrunkTracker™.
Changing the Display Mode
While monitoring a trunking bank in any of the trunk
modes, press 
to change the display mode. You can display one of the following conditions:
Current Scan List
nCurrent Active Banks Repeater Activity Indicators
You will find more information on these channel activity indicators later in this section.
42