Uniden BC 245XLT manual Try another Preset Fleet Map or Program

If you experience difficulty while in TrunkTracker™ mode, try the following steps.

Problem		Suggestion
Scanner won’t track the trunked	1.	May not be a system which can be tracked by
system.		your scanner.
	2.	Missing the data frequency.
	3.	Change to a Type 1 Scanner setup.
		Review Fleet Map Programming on page 56.
Scanner won’t stop during Scan	1.	No IDs have been programmed.
List mode.	2.	The IDs you have stored are not active.
Scanner will not acquire data	1.	Adjust the squelch for trunking mode.
channel.		See page 39.
	2.	Missing the frequency used for the data
		channel. Check your frequency list.
Missing replies to conversations.	1. Change to a Type 1 Scanner setup.
		Review Fleet Map Programming on page 56.
	2.	Try another Preset Fleet Map or Program
		your own Fleet Map.
	3.	Check to see that all of the systems
		frequencies have been entered.
Channel Activity Indicators are	1.	May be a private or telephone
flashing but no sound is heard.		interconnect call, which are intentionally
		blocked by your scanner.
	2.	The ID in your display is not active.
Scanner not tracking an EDACS	1.	Logical channel numbers ( frequencies)
system properly.		for the system are not programmed in the correct
		order. Check frequency resources and reprogram.
	2.	Not all frequencies for the system are
		programmed. Check frequency resources.

If you still cannot get satisfactory results while using your scanner or if you want additional information, please call or write the Uniden Parts and Service Division. The address and phone number are listed in the Warranty at the end of this manual. If you would like immediate assistance, please call Customer Service at (800) 297-1023.

If you have internet access, you can visit www.uniden.com or www.trunktracker.com or www.bearcat1.com/free.htm for additional information.

77