Zebra Technologies PR4T manual Indicators under each battery will allow, Table below

Charging the P4T Series Battery with the UCLI72-4 Quad Charger

Manual Introduction	RP4T Printers 35
pg.	pg.
4

Figure 5- UCLI72-4 Quad Charger

Slide Battery Pack into a Charger bay

The UCLI72-4 Quad Charger is designed to charge up to four battery packs simultane- ously. Charging times are as follows:

Battery Status	Charging Time
80% charged	2.5 Hrs.
Full charge	5 Hrs.

P4T/RP4T User Guide

P4T Overview- pg. 5	Maintenance pg. 36
Printer Preparation pg. 7	Troubleshooting pg. 38

Power Supply

Rock Battery

Pack into place

Fast
Charge	Full
Fault		Charge
		Ready

Fast
Charge	Full
Fault		Charge
		Ready

Fast
Charge	Full
Fault		Charge

•Ensure that the charger has been installed properly per the Quad Charger instruction manual. Ensure that the power indicator on the front panel is on.

•Remove any protective shrink-wrap and labels from all battery packs prior to first use. Plug a battery pack into any one of the four charging bays as shown opposite in Figure _, noting the orientation of the battery pack.

•Slide the battery pack into the charging bay until it stops.

•Rock the battery pack back until it snaps into place.

The amber indicator directly under the bat- tery being charged will turn on if the battery is properly inserted.

Connecting Printer Speci†cations

			Ready	Charge	Full			The indicators under each battery will allow
			Fast
Amber	Green		Fault			Charge		you to monitor the charging process per the
		Charger		Power		Ready
Indicator	Indicator							table below:
		Bay					Power Indicator

pg.	43
the 27	pg.
Radio Regulatory Information	Appendices

Important • A fault condition (flashing amber indicator) is caused by a problem with the battery pack. The charger may indicate a fault because the battery is too hot or too cold to charge reliably. Try to charge the battery again when it returns to the room’s ambient temperature. If the amber indicator starts flashing on the second charging attempt, the battery should be discarded. Always dispose of batteries in a proper manner. Refer to Appendix E of this manual.

Amber	Green	Battery Status
On	O¨	Charging
On	Flashing	80% charged
		(O.K. to use)
O¨	On	Completely
		Charged
Flashing	O¨	Faulty Battery

pg. 31	pg. 46
	Index pg. 52

Notes: For more information regarding the installation and use of the UCLI72-4 Quad Charger refer to the instructions included with the product.

The UCLI72-4 Quad Charger has a safety feature which stops charging a battery after six hours regardless of its charge state.

Section Continues 15