Zebra Technologies P100iTM manual Installing the P100i Printer

Printer Installation

Installing the P100i Printer

Installing the P100i Printer

Caution • Do not power the printer with USB attached to your computer until the driver has been installed or until prompted by the driver.

Caution • Limit electrical power supplied to the P100i Printer to 24 VDC. Limit excess current draw to 16 amps or less, using an associated circuit breaker or other such device. Never operate the printer in a location where operator, computer, or printer can get wet. Personal injury could result. The printer must be connected to an earthed electrical power supply and properly protected against electrical surges and grounding faults. The power supply pack can only be replaced by the same product from the manufacturer.

1.Place the printer in a location that allows easy access to all sides. The printer should never be operated while resting on its side or upside down

2.Remove the yellow CAUTION label from the back of the printer.