Dicota Phasor manual Mouse not detected, Screen Cursors does not move properly, Disclaimer

Page 7

Make sure the receiver is plugged in the USB port.

Unplug the receiver and then plug in the receiver again. Make sure that it had been detected by the Operating Systems properly.

B. Mouse not detected

When using the mouse, it may not be detected by the Notebook/compu- ter or receiver. To remedy this problem, try the following:

Make sure the receiver is plugged in the USB port.

You may re-setup the connection RF Channel between the mouse and the receiver, especially, when you have been changed or recharged your batteries.

C. The Screen Cursors does not move properly

Change the angle of your radio receiver. Try adjusting the receiver and/or mouse to improve reception.

Make sure that the battery low indicator is NOT lit on. Replace batteries if the low battery indicator is lit on.

You may also need to change the RF Channel for the mouse. Press the “Channel Reset” button on the receiver, then press the “Channel Reset” button on the mouse.

Disclaimer

Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties (im- plied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any commercial damage, including but not limited to special, incidental, consequential, or other damage. No part of this document may be reproduced or transmitted in any form by any means, electronic or mechanical, including photocopying, recording or information record- ing and retrieval systems without the express written permission of the manufacturer.

7

Image 7
Contents Ratón inalámbrico a láser recargable Wireless Rechargeable Laser MouseKabellose aufladbare Laser-Maus Souris capteur laser sans fil rechargeableWelcome Functional introduction Safety noticeOperation system Install the receiver Installing the batteriesPush Recharging TroubleshootingUsing your Phasor How to use the wheel Mouse does not work upon installationScreen Cursors does not move properly Mouse not detectedDisclaimer Customer Service Deutsch Betriebssystem WillkommenFunktionelle Einführung SicherheitshinweisVorsicht Installation des EmpfängersDrücken Installation des RF-Kanals zwischen Maus und EmpängerPhasor benutzen Verwendung des Mausrads ProblemlösungMaus funktioniert nach Installation nicht AufladenDie Zeiger auf dem Bildschrim bewegen sich nicht korrekt Maus wird nicht erkanntHaftungsausschluss Kundenservice Bienvenue Consignes de sécurité Présentation des fonctionsSystème d’exploitation Connexion au port USB de votre ordinateur portable Installation du récepteurInitialisation du canal RF entre la souris et le récepteur AppuyerUtilisation de la souris Phasor Utilisation de la molette Une fois installée, la souris ne fonctionne pasDépannage RechargeClause de non-responsabilité La souris n’est pas reconnueService Clientèle Bienvenido Consejo de seguridad Presentación de las funcionesSistema operativo Instalación del receptor AtenciónInstalación del canal RF entre el ratón y el receptor PresioneEl ratón no funciona después de su instalación Resolución de problemasCarga Utilización del Phasor Utilización de la rueda del ratónLos punteros no se desplazan correctamente por la pantalla No se detecta el ratónExclusión de responsabilidad Servicio al cliente Benvenuti Avvertimenti di sicurezza Introduzione al funzionamentoAttenzione Installazione del ricevitoreImpostazione del canale RF tra mouse e ricevitore PremereUsare Phasor Usare la rotella del mouse Ricerca erroriIl mouse non funziona dopo l’installazione CarciamentoLa freccia sullo schermo non si mouve correttamente Il mouse non viene riconosciutoEsclusione della responsabilità Servizio di assistenza