USING THE 50.2 SIGNAL SWITCHING NETWORK
The Punch 50.2 Power amplifier has a crossover switching network which enables you to:
•“Audiophile Bypass” the 50.2 and
•Configure a 12dB per octave filter for both 50.2 and
•“Audiophile Bypass” the 50.2 and configure a 12dB per octave filter for the
•Configure a 24dB per octave filter for the 50.2 and “Audiophile Bypass” the
•Configure a 12dB per octave bandpass filter for the 50.2 and “Audiophile Bypass” the
I
N
S T A L L A T I O N
The crossover switching network allows the crossover to be distributed to the amplifier and Pass Thru in many different configurations. The orientation of both switches configure the distribution pattern to where the crossover signal will be routed.
XCard Options
Amplifier | Pass Thru |
XCard 1 | XCard 2 |
AmplifierAmplifier
XCard 1 | XCard 2 |
®
50.2 A M P L I F I E R
P O W E R
25 Watts X 2 into 4 Ohms
with less than 0.05% THD + N from
50 Watts X 2 into 2 Ohms
with less than 0.10% THD + N from
®
ROCKFORD CORPORATION
MADE IN THE USA
XCard 2
HP |
LP |
LP
Audiophile Bypass
|
|
| Not Used | Not Used |
| |||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| XCard 1 |
|
|
|
|
|
|
| XCard 2 |
|
|
| 1 | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| XCard |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| Audiophile Bypass | ||||||||||||||||
|
|
|
|
|
|
|
|
| ||||||||||||||||
|
|
|
| Not Used Amp Only | Pass Thru |
| ||||||||||||||||||
XCard 1 | XCard 2 |
HP
Full Range
FULL
*Bridging Note: The Punch 50.2 can be
bridged in many configurations. Refer to your owner's manual to determine which mode will work best in your system.
– 19 –