Rockford Fosgate 351M manual Installation Remote Punch Bass, Operation Adjusting Gain

Page 8

INSTALLATION

 

REMOTE PUNCH BASS

Mounting

Mounting and installation

Clip

1. Find a location, either under the dash or

 

near the center console, that gives easy

 

access to the remote.

 

2. Using the screws supplied, install the mounting clip with the tabs towards the back.

3. Route the cable for the remote and connect to both the remote and amplifier.

4.

Slip the remote onto the mounting clip

Decal

 

 

 

 

until it snaps into place.

Knob

 

 

 

 

5.

Place the decal onto the remote and use

Nut

 

the nut to hold the decal in place. Do

 

 

 

 

not over tighten nut.

6. Install the knob onto the remote.

OPERATION

ADJUSTING GAIN

To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up until distortion is audible and then turn it down a bit until the distortion is inaudible. This will be about two thirds all the way up on most source units. Next, turn the amplifier gain setting until once again distortion is audible and then back it down until the distortion is inaudible. Rockford Fosgate source units do not distort, so the volume can be used at maximum setting.

NOTE: For a more in depth setting procedure, contact Rockford Technical Support.

ADJUSTING CROSSOVER FREQUENCY

Placing the switch in the AP position sets the amplifier to the all pass frequency mode, preventing any crossover adjustment.

Placing the switch in the LP position allows the crossover frequency to be adjusted between 50-250Hz.

Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover adjustment knob up slowly until the desired crossover point is achieved.

8

Image 8
Contents Mono Amplifier Table of Contents IntroductionSafety Instructions Contents of CartonDesign Features Installation Installation ConsiderationsInstallation Battery and ChargingBy a qualified technician Mounting LocationsInstallation Wiring the System Using Passive Crossovers Speaker ImpedanceAdjusting Crossover Frequency Installation Remote Punch BassOperation Adjusting Gain Troubleshooting Procedure 1 Check Amplifier for proper connectionsProcedure 2 Check Amplifier for audio output Procedure 3 Check Amplifier if you experience Turn-on Pop351M Specifications Model PowerContinuous Power Rating RMS Measured at 14.4 Battery Volts Length of Warranty Limited Warranty InformationFrançais Table DES MatièresConsignes DE Sécurité Contenu DE LemballageInstallation Considérations Concernant L’INSTALLATION Particularités TechniquesEmplacements DE Montage Batterie ET ChargeInstallation Câblage DU Système Utilisation DE Filtres Passifs Impédance de haut-parleurMontage et installation Autocollant Bouton LécrouFonctionnement Réglage DU Gain Réglage DE LA Fréquence DU Filtre PassifAccessoires DépannageProcédure 2 Vérifiez la sortie audio de l’ampli Condensateurs de connexion PunchCaractéristiques Modèle Puissance nominale en continu RMS Mesurée à 14,4 V batterieDurée de la garantie Garantie LimitéeIntroducción Índice DE MateriasInicio Instrucciones DE SeguridadCaracterísticas DEL Diseño Instalación Consideraciones Sobre LA InstalaciónInstalación Técnico calificado que lo instaleLugares DE Montaje Batería Y CargaInstalación Cableado DEL Sistema USO DE X-OVERS Pasivos Impedancia del altavozBajo Punch Remoto Punch Bass PerillaTuerca Operación Ajuste DE LA GananciaSolución DE Problemas AccessoriosCapacitores conectores Punch Conexión de acoplesEspecificaciones Modelo Amplificadores POWER-2 añosAmplificadores Type RF-3 años Información Sobre LA Garantía LimitadaEinleitung InhaltsverzeichnisInhalt DES Kartons SicherheitshinweiseAm Gerät, Feuer bzw. mögliche Verletzungen zu vermeiden Designcharakteristiken Einbau EinbauüberlegungenBatterie UND Aufladung EinbauBefestigungsstellen Einbau Verkabelung DES Systems Verwendung VON Passiven Crossovern LautsprecherimpedanzCROSSOVER-FREQUENZ Einstellen Einbau PUNCHBASS-FERNBEDIENUNGBetrieb Lautstärke Gain Einstellen Fehlerbeseitigung Verfahren 2 Die Audioleistung des Verstärkers prüfenOder OrerTechnische Daten Modell Leistung 351M SchutzLaufzeit der Garantie Informationen ZUR Beschränkten GarantieIntroduzione IndiceIstruzioni DI Sicurezza Contenuto DELL’IMBALLAGGIOInstallazione Considerazioni SULL’INSTALLAZIONE Caratteristiche DEL DesignBatteria E Caricamento InstallazionePosizionamento Installazione Cablaggio DEL Sistema AttenzioneImpedenza dell’altoparlante Come Usare LE Frequenze DI Incrocio PassiveAttenzione Questi Montaggio ed installazione DadoFunzionamento Regolazione DI Guadagno Regolazione Della Frequenza DI IncrocioAccessori Condensatori della Connecting PunchINDIVIDUAZIONE/RIPARAZIONE Guasti OppureSpecifiche Modello Power 351M Misurata a 14,4 volt da batteriaLunghezza della garanzia Informazioni Inerenti Alla Garanzia LimitataRockford Fosgate

351M specifications

Rockford Fosgate is a brand synonymous with premium sound performance, particularly in the realm of car audio equipment. One of their standout products is the Rockford Fosgate 351M, a powerful marine amplifier designed to deliver exceptional audio clarity and loudness in rugged environments, such as on boats and other watercraft.

The Rockford Fosgate 351M is a 3-channel amplifier that brings versatility and power to any marine audio setup. With an impressive power output of 50 watts per channel at 4 ohms, it ensures that audio enthusiasts can enjoy their music with remarkable depth and clarity, even in the noisy environment of an open water setting. This amplifier is also capable of delivering a maximum output power of up to 150 watts at 2 ohms, making it ideal for driving multiple speakers with ease.

One of the remarkable features of the 351M is its Class D topology, which promotes greater efficiency and reduces heat production compared to traditional amplifier designs. This ensures that the amplifier performs optimally without the risk of overheating, even during extended listening sessions. Additionally, its compact size allows for easy installation in limited spaces, making it a practical choice for any marine audio system.

The 351M is built with marine-grade materials, offering IPX6 water and dust protection. This means it can withstand splashes and saltwater exposure, providing peace of mind for users who wish to use it in challenging outdoor conditions. The amplifier's rugged construction ensures a long lifespan and reliable performance, even in the harshest marine environments.

Integrated features such as integrated crossover filters allow users to tailor their sound more precisely. This ensures that highs, mids, and lows can be optimized for various speaker systems, providing a truly immersive listening experience. Furthermore, the amplifier comes with RCA line outputs, enabling easy expansion and linking with additional amplifiers if required.

The Rockford Fosgate 351M is the ideal solution for marine audio enthusiasts seeking quality amplification for their sound systems. With its advanced technology, durable construction, and user-friendly features, it stands out as a top choice for those looking to enhance their boating experience with high-performance audio. Whether you're cruising on a lake or taking on the open sea, the 351M provides the power and clarity needed to enjoy your favorite tunes.