Command Reference
ASCII | ESC d |
Decimal | 27 100 |
Hex | 1B 64 |
Parameters
None
ESC E Form Feed
Description
Prints the contents of the text buffer and advances the print media. The distance the media will advance depends on two factors: the feed distance specified by the GS L command and the presence of a punch hole. The LabelWriter printer will advance until a punch hole is detected or until the feed distance (specified by the GS L command) has been reached.
When the printer is powered on, the feed distance stored in flash memory is used as the default distance; the factory default is 7.5 inches. A new feed distance specified by the GS L command will override the flash memory setting until the printer is either powered down or a reset command is issued (by the ESC @ or ESC * command).
The FF and ESC E commands are the same and produce the same result.
See Also
FF
Expression
ASCII | ESC E |
Decimal | 27 69 |
Hex | 1B 45 |
Parameters
None
ESC e Set Print Temperature to Default
Used to adjust the printing strobe.
This command is also supported by the LabelWriter SE300 and the LabelWriter 400 and 450 series printers.
Expression
ASCII | ESC e |
Decimal | 27 101 |
Hex | 1B 65 |
Parameters
22