SATO ct4i manual Parameter Default Setting, Default Settings Mode Online + Feed + Power on

Unit 4: Printer Configuration

4.4.3 Default Settings Mode (ONLINE + FEED + POWER ON)

Turning the printer ON in this mode simply resets major settings to their default values. (See table). After the default values have been restored, the printer emits three beeps. The ERROR LED also lights up during the reset operation, but goes off after the settings have been activated.

Parameter	Default Setting
Reference position	Vertical: 0dot, Horizontal: 0dot
Pitch offset	0 dot
Cut position offset	0 dot
Dispensing position offset	0 dot
Tear off position offset	0 dot
Label size (Pitch, width)	Pitch=3200 dot x width 832dot [8dots/mm]
	Pitch=4800 dot x width 1248dot [12dots/mm]
	Pitch=9600 dot x width 2496dot [23.6 dots/mm]
Print speed	100 mm/s [8dots/mm] [12dots/mm]
	50 mm/s [23.6dots/mm]
Print darkness	3A [Direct thermal]
	3B [Thermal transfer]
Sensor type	Gap
Kanji character code	JIS
Paper end detection means	Roll type
Zero slash	Enable
Proportional pitch	Enable [CT Series]
Buzzer	Enable
Initial feed	Disable
Auto-feed	Disable
Gap size	24dots [8dots/mm]
	36dots [12dots/mm]
	72dots [23.6dots/mm]
Optional operation modes	Operation No. 1
VR (Potentiometer)	Option stop position offset =0, print darkness=0
Interface settings	IEEE1284: Multi buffer, ACK width =500ns
	RS-232C: Baud rate=19200bps, Data-bit=8bit, Parity=off, Stop bit=1bit, Con-
	trol=READY/BUSY control (multi- buffer)
	LAN/Wireless LAN: Driver exclusive protocol (Status 4) cycle response mode (2-
	port connection using Port 1024 and Port 1025, or 1 port connection using Port
	9100.)
	USB: (no default settings)
	Bluetooth: Bluetooth mode = Status 4, PIN code = 0000000000000000, Authenti-
	cation mode = Authentication Level 1, ISI=0800, ISW=0012, PSI=0800, PSW=0012,
	Device name = SATO ONLINE PRINTER, CRC Check = Disable

CT4i Series Operator Manual 4-10