RCA Fibre Channel Switch installation manual Configuring Fibre Channel on your PDR Series systems

Page 12

Loading Fibre Channel Server firmware

If you wish to connect a Profile Fibre Channel Server to a QLogic SANbox2 Switch, you must load switch-compatible firmware on all the Fibre Channel boards installed in your server. You must also install the appropriate Fibre Channel drivers that can use all the features of the new firmware.

NOTE: A Profile Fibre Channel Server consists of an SGI O200 or O2000 system equipped with Fibre Channel boards purchased from Grass Valley. If your Fibre Channel boards were purchased obtained from another source, please ask your supplier about compatibility with the QLogic SANbox2 Switch.

To load switch-compatible firmware on your Fibre Channel Server boards:

1.Contact Grass Valley support to obtain the location of the latest firmware, then download the files from that location.

2.Place the files in the /temp/drivers on the destination SGI server.

3.Follow the instructions in the Genrocco Fibre Channel Adapter Installation Manual to load the firmware onto each of the Fibre Channel boards.

4.Follow the instructions in the Genrocco Fibre Channel Adapter Installation Manual to install the appropriate driver on the system.

5.Reboot the SGI server.

Configuring Fibre Channel on your PDR Series systems

Once you’ve installed the required version of Profile System Software and loaded the appropriate firmware and drivers on all the devices you are connecting to the switch, you must configure each Profile Video File Server or Profile Fibre Channel Server for operation in a Fibre Channel fabric environment.

NOTE: Profile XP Media Platforms are pre-configured for operation in a fabric (switched) Fibre Channel Environment. You must not perform this procedure on a Profile XP system.

To configure your Profile Fibre Channel server or any device other than your Profile system, refer to the installation manual for that device for instructions.

12

Fibre Channel Switch

16 April, 2003

Image 12
Contents Fibre Channel Switch Fibre Channel Switch Contents Contents Web Technical Support Phone SupportAuthorized Support Representative Profile Users GroupProduct Support Welcome How to use the manuals Support for your Fibre Channel switchInstalling a Switch in a Profile Video Network Profile System Software Requirements PDR Series Fibre Channel firmware and driver requirements Loading PDR Series firmwareConfiguring Fibre Channel on your PDR Series systems Loading Fibre Channel Server firmwareConfiguring Fibre Channel on your PDR Series Configuring your Fibre Channel switch Enter administrator modeConfigure Ethernet LAN settings Configuring your Fibre Channel switch Verify firmware versionPort and switch configuration ArbffRttov ThresholdMonitoringEnabled True / False Connecting devices to the switch Cable lengthsFabric topology Compatible Fibre Channel DevicesMonitoring your switch with NetCentral Snmp configuration Fibre Channel Switch Setting port aliases Monitoring Status Monitoring Status Troubleshooting with NetCentral Resetting the switch to factory defaults Resetting the switch manuallyFibre Channel Switch