To discard this configuration use the config cancel command.
7.Type the following command to save your configuration. sb5_8port
8.Type the following command to activate your configuration. sb5_8port
9.Type the following commands to view the threshold advanced settings: sb2_16port #> admin start
sb2_16port (admin) #> config edit
sb2_16port
10. Verify that the ThesholdMonitoringEnabled setting is False, or modify it if needed.
A list of attributes | with formatting and current values will follow. | ||||
Enter a new value or | simply press the | ENTER key to accept the current value. | |||
If you wish to terminate this process | before reaching the end of the list | ||||
press 'q' or 'Q' and | the ENTER key to | do so. |
|
| |
ThresholdMonitoringEnabled | (True / False) | [True] | False | ||
q |
|
|
|
|
|
Finished configuring | attributes. |
|
|
|
|
This configuration must be saved (see | config save command) and |
| |||
activated (see config activate command) before it can take effect. |
| ||||
To discard this configuration use the | config cancel command. |
| |||
11.Save and activate the configuration with the following commands: sb2_16port
12.Confirm activation of the configuration when prompted.
You must make various SNMP settings so that you can monitor your switch with NetCentral. Refer to “Monitoring your switch with NetCentral” on page 20 for SNMP configuration information.
If you are installing your QLogic SANbox2 Switch in a Grass Valley Media Area Network, refer to the Media Area Network Instruction Manual for specific configuration information.
18 | Fibre Channel Switch | 16 April, 2003 |