MGE UPS Systems 30A user manual Upsilon STS 30 to 250 a Input Phases + PEN Output

Page 13

2. Installation

Upsilon STS 30 to 250 A

Input:

3 phases + PEN

 

Output:

3 phases + PE

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to threaded studs (diameter 8 mm).

The cables are tied to the earth bar.

N L1 L2 L3

N L1 L2 L3N L1 L2 L3

 

N

 

PEN

PE

PEN

 

 

275 mm

 

S1

S2

Upsilon STS 30 to 250 A Input: 3 phases + PE + Neutral Output: 3 phases + PE + Neutral

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to threaded studs (diameter 8 mm).

The cables are tied to the earth bar.

N L1 L2 L3

N L1 L2 L3N L1 L2 L3

NNN

PE PE PE

275 mm

S1

S2

Upsilon STS 30 to 250 A

Input: 3 phases + PE

 

Output: 3 phases + PE

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to threaded studs (diameter 8 mm).

The cables are tied to the earth bar.

N L1 L2 L3

N L1 L2 L3N L1 L2 L3

PE PE PE

275 mm

S1

S2

34020113EN/AA - Page 13

Image 13
Contents Upsilon STS 2 34020113EN/AA Introduction Foreword Using this documentPictograms DocumentContents Appendix Upsilon STS 30 60 100 160 250 a cabinet 1400 mm high PresentationUpsilon STS 30 60 100 160 250 a cabinet 1400 mm high Access to control and connectionsFunction buttons Man / machine interfaceJBus communication card Relay communication cardOutput terminal block Positioning InstallationPower connections Upsilon STS 30 to 250 a Input Phases + PEN Output L1 L2 L3 Upsilon STS 400 to 600 a Input Phases + PEN Output Connection of the emergency power off terminal block Connection of the Jbus communication card Connection of the communication cardsRS232 RS485Characteristics of the input contacts Characteristics of the output contactsConnection of the relay communication card Operation Load is not supplied with powerStart-up ShutdownOperation on the preferred source Normal mode. Operation on preferred source S1Automatic transfer to the alternate source Manual transfer to the alternate sourceManual transfer to an out-of-phase alternate source Main screen Display screensUpsilon STS customization Factory setting CustomizationSignals available on each contact Inputs Factory settingCustomization of the relay communication card Identification of anomalies MaintenanceTransfer to the manual bypass Environment UPS recycling at the end of service lifeAppendix Upsilon STS simplified diagram Simplified diagramsSimplified diagram of an installation Glossary Connections Index