MGE UPS Systems 30A user manual L1 L2 L3

Page 14

2. Installation

See section 6.1 for information on sizing protection devices and cables (Appendix, Technical data).

A maximum of four cables may be used per phase.

Upsilon STS 400 to 600 A	Input: 3 phases + PEN
	Output: 3 phases + PEN

N L1 L2 L3 N L1 L2 L3N L1 L2 L3

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to two threaded studs per phase (diameter 10 mm).

The cables are tied to the earth bar.

				463
				mm
		N		403
		S1	S2	403
		S1	S2	mm
	PEN	PEN	PEN	mm
	PEN	PEN	PEN

Upsilon STS 400 to 600 A	Input:	3 phases + PEN
	Output:	3 phases + PE + Neutral

N L1 L2 L3

N L1 L2 L3

N L1 L2 L3

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to two threaded studs per phase (diameter 10 mm).

The cables are tied to the earth bar.

					463
		N			mm
		N			403
	S1	N		S2	403
	S1			S2	mm
PEN		PE	PEN		mm
PEN		PE	PEN

Page 14 - 34020113EN/AA

Image 14

Contents Upsilon STS 2 34020113EN/AA Introduction Pictograms Using this documentForeword DocumentContents Appendix Presentation Upsilon STS 30 60 100 160 250 a cabinet 1400 mm highAccess to control and connections Upsilon STS 30 60 100 160 250 a cabinet 1400 mm highMan / machine interface Function buttonsOutput terminal block Relay communication cardJBus communication card Installation PositioningPower connections Upsilon STS 30 to 250 a Input Phases + PEN Output L1 L2 L3 Upsilon STS 400 to 600 a Input Phases + PEN Output Connection of the emergency power off terminal block RS232 Connection of the communication cardsConnection of the Jbus communication card RS485Connection of the relay communication card Characteristics of the output contactsCharacteristics of the input contacts Start-up Load is not supplied with powerOperation ShutdownAutomatic transfer to the alternate source Normal mode. Operation on preferred source S1Operation on the preferred source Manual transfer to the alternate sourceManual transfer to an out-of-phase alternate source Display screens Main screenFactory setting Customization Upsilon STS customizationCustomization of the relay communication card Inputs Factory settingSignals available on each contact Transfer to the manual bypass MaintenanceIdentification of anomalies UPS recycling at the end of service life EnvironmentAppendix Simplified diagram of an installation Simplified diagramsUpsilon STS simplified diagram Glossary Index Connections