MGE UPS Systems 30A user manual Upsilon STS 400 to 600 a Input Phases + PEN Output

Page 15

2. Installation

Upsilon STS 400 to 600 A	Input:	3 phases + PEN
	Output:	3 phases + PE

N L1 L2 L3 N L1 L2 L3N L1 L2 L3

See section 1.3 for information on accessing the connections. Connections are made using lugs connected to two threaded studs per phase (diameter 10 mm).

The cables are tied to the earth bar.

			463
			mm
	N		403
			403
	S1	S2	mm
PEN	PE	PEN

Upsilon STS 400 to 600 A Input: 3 phases + PE + Neutral Output: 3 phases + PE + Neutral

N L1 L2 L3 N L1 L2 L3N L1 L2 L3

N	N	N			463
N	N	N			mm
					mm
	S1			S2	403
PE	PE		PE		403
PE	PE		PE		mm
					mm

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to two threaded studs per phase (diameter 10 mm).

The cables are tied to the earth bar.

Upsilon STS 400 to 600 A	Input: 3 phases + PE
	Output: 3 phases + PE

N L1 L2 L3 N L1 L2 L3N L1 L2 L3

See section 1.3 for information on accessing the connections. Connections are made using lugs connected to two threaded studs per phase (diameter 10 mm).

The cables are tied to the earth bar.

				463
				mm
	S1		S2	403
	S1		S2	mm
PE	PE	PE		mm
PE	PE	PE

34020113EN/AA - Page 15

Image 15

Contents Upsilon STS 2 34020113EN/AA Introduction Document Using this documentForeword PictogramsContents Appendix Upsilon STS 30 60 100 160 250 a cabinet 1400 mm high PresentationUpsilon STS 30 60 100 160 250 a cabinet 1400 mm high Access to control and connectionsFunction buttons Man / machine interfaceRelay communication card JBus communication cardOutput terminal block Positioning InstallationPower connections Upsilon STS 30 to 250 a Input Phases + PEN Output L1 L2 L3 Upsilon STS 400 to 600 a Input Phases + PEN Output Connection of the emergency power off terminal block RS485 Connection of the communication cardsConnection of the Jbus communication card RS232Characteristics of the output contacts Characteristics of the input contactsConnection of the relay communication card Shutdown Load is not supplied with powerOperation Start-upManual transfer to the alternate source Normal mode. Operation on preferred source S1Operation on the preferred source Automatic transfer to the alternate sourceManual transfer to an out-of-phase alternate source Main screen Display screensUpsilon STS customization Factory setting CustomizationInputs Factory setting Signals available on each contactCustomization of the relay communication card Maintenance Identification of anomaliesTransfer to the manual bypass Environment UPS recycling at the end of service lifeAppendix Simplified diagrams Upsilon STS simplified diagramSimplified diagram of an installation Glossary Connections Index