American Power Conversion RT XLI/XLICH user manual Route ethernet cable and install bezels

Page 10

Route ethernet cable and install bezels

Ethernet cable wiring rear panel access

Locate the RJ45 connector and the ethernet port on the front panel of the UPS. Connect the ethernet jumper cable (included), to the RJ45 connector and the ethernet port.

Connect a network cable (not included), to the RJ45 connector on the rear panel of the UPS.

There is an internal ethernet cable that connects

the front and rear panel RJ45 connectors.Ethernet Cable

RJ45 Connector

Ethernet Jumper Cable

Ethernet

Port

Ethernet Cable connected to rear panel RJ45 connector

Internal pass through ethernet cable connecting front and rear panel RJ45 connectors

Ethernet cable wiring front panel access

Ethernet Port

Ethernet Cable

Cables that are connected to the UPS for front panel access must be routed through one of the notches on the bezel.

6	Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

Image 10

Contents XLI/XLICH Page Contents Page Unpack package contents About this UPSPhysical Specifications SpecificationsEnvironmental Specifications Maximum Number of XLBPs Supported by the Smart-UPS XLInstallation Stack or rack-mount front panelStack configuration Rack-mount configurationInstall units in rack Install and connect battery modulesRoute ethernet cable and install bezels Accessories Optional accessoriesInstall the wiring trays, refer to graphics below Install input and output wiring trays in UPS rear panel XlbpWiring Specifications Adhere to national and local electrical codes when wiringInput wiring options Input/Output Jumper ConfigurationsSingle phase input, single phase output, single feed Single phase input, single phase output, dual feedThree phase input, single phase output, dual feed Three phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, three phase output, dual feedOutput wiring options L3 L2 L1 OSJSingle phase output connection to battery pack PDU PowerView Interface Display OperationNavigating menu screens Main Menu ScreenMenu Tree Navigating sub menu screensSub menu screens SystemExternal Battery Pack Connect load to UPS Connect power to UPS and loadCommunication Ports Emergency Power Off EPO ConnectorTroubleshooting Display Messages Output Jumper Configurations tablePage Refer to Contact Information in this Option 2 Correct bypass input Replace battery modules Maintenance, Transport, and ServiceService Two-Year Warranty Terms of warrantyRegulatory Agency Approvals and Radio Frequency Warnings ModelsDate of product declaration