American Power Conversion RT XLI/XLICH Install input and output wiring trays in UPS rear panel

Page 13

Install input and output wiring trays in UPS rear panel

Input Wiring	RJ45	XLBP	Output Wiring
Tray	Connector	Connector	Tray

Ground

EPO Port

Cold Start/EPO Reset

Ground

Input Wiring Tray

Output Wiring Tray

Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

9

Image 13

Contents XLI/XLICH Page Contents Page About this UPS Unpack package contentsEnvironmental Specifications SpecificationsPhysical Specifications Maximum Number of XLBPs Supported by the Smart-UPS XLStack or rack-mount front panel InstallationRack-mount configuration Stack configurationInstall and connect battery modules Install units in rackRoute ethernet cable and install bezels Optional accessories AccessoriesInstall the wiring trays, refer to graphics below Xlbp Install input and output wiring trays in UPS rear panelAdhere to national and local electrical codes when wiring Wiring SpecificationsInput/Output Jumper Configurations Input wiring optionsSingle phase input, single phase output, dual feed Single phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, single phase output, single feedThree phase input, single phase output, dual feed Three phase input, three phase output, dual feedL3 L2 L1 OSJ Output wiring optionsSingle phase output connection to battery pack PDU Operation PowerView Interface DisplayMain Menu Screen Navigating menu screensNavigating sub menu screens Menu TreeSystem Sub menu screensExternal Battery Pack Connect load to UPS Connect power to UPS and loadCommunication Ports Connector Emergency Power Off EPOOutput Jumper Configurations table Troubleshooting Display MessagesPage Refer to Contact Information in this Option 2 Correct bypass input Replace battery modules Maintenance, Transport, and ServiceService Terms of warranty Two-Year WarrantyModels Regulatory Agency Approvals and Radio Frequency WarningsDate of product declaration