American Power Conversion RT XLI/XLICH user manual About this UPS, Unpack package contents

Page 5

Introduction

About this UPS

The American Power Conversion (APC®) Smart-UPS® RT is a high performance uninterruptible power supply (UPS) that provides protection for electronic equipment from utility power blackouts, brownouts, sags and surges. The UPS protects electronic equipment from small utility fluctuations and large disturbances by providing continuous on-line double converted power. The UPS provides battery backup until utility power returns to safe levels or the batteries are fully discharged.

The UPS and the external battery pack (XLBP) are packaged separately.

Unpack package contents

Read the Safety Guide before installing the UPS.

Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage.

The packaging is recyclable; save it for reuse or dispose of it properly.

Check the package contents:

UPS

• Literature kit containing:

Rack-mount models also include:

Input wiring tray

Product documentation

Rail Kit

Output wiring tray

Smart-UPS® RT User Manuals CD

Four ornamental screws

PowerView display module

– Network Management Card Utility CD

Two cage nuts

Front bezel

Network Management Card

Two rail cleats

DB9 serial cable

 

documentation

– Four pan head screws

Ethernet jumper cable for rear

 

 

panel network access

Safety information

Two rack-mount brackets

 

 

Warranty information

– Eight flat head screws

 

 

 

 

 

 

NOTE: The model and serial numbers are located on a small, rear panel label. For some models, an additional label is located on the chassis under the front bezel.

Hardware for rack-mount

models4 Rack-mount units:

pan head screws for securing rail cleats to UPS

8Flat head screws for securing

rack-mount brackets or tie brackets to the unit

Rack-mount units:

4ornamental screws for securing the unit to the rack

2

Rack-mount units:

cage nuts for rack installation

 

2

rack-mount brackets

 

2

rail cleats

 

Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

1

Image 5
Contents XLI/XLICH Page Contents Page About this UPS Unpack package contentsEnvironmental Specifications SpecificationsPhysical Specifications Maximum Number of XLBPs Supported by the Smart-UPS XLStack or rack-mount front panel InstallationRack-mount configuration Stack configurationInstall and connect battery modules Install units in rackRoute ethernet cable and install bezels Optional accessories AccessoriesInstall the wiring trays, refer to graphics below Xlbp Install input and output wiring trays in UPS rear panelAdhere to national and local electrical codes when wiring Wiring SpecificationsInput/Output Jumper Configurations Input wiring optionsSingle phase input, single phase output, dual feed Single phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, single phase output, single feedThree phase input, single phase output, dual feed Three phase input, three phase output, dual feedL3 L2 L1 OSJ Output wiring optionsSingle phase output connection to battery pack PDU Operation PowerView Interface DisplayMain Menu Screen Navigating menu screensNavigating sub menu screens Menu TreeSystem Sub menu screensExternal Battery Pack Communication Ports Connect power to UPS and loadConnect load to UPS Connector Emergency Power Off EPOOutput Jumper Configurations table Troubleshooting Display MessagesPage Refer to Contact Information in this Option 2 Correct bypass input Service Maintenance, Transport, and ServiceReplace battery modules Terms of warranty Two-Year WarrantyModels Regulatory Agency Approvals and Radio Frequency WarningsDate of product declaration