American Power Conversion RT XLI/XLICH Environmental Specifications, Physical Specifications

Page 6

Specifications

Environmental Specifications

	Temperature	32° to 104° F (0° to 40° C)	This unit is intended for indoor use only.
	Operating	32° to 104° F (0° to 40° C)	Select a location sturdy enough to handle
	Storage	5° to 113° F (-15°to 45° C) charge the UPS battery every	the weight.
		six months	Do not operate the UPS where there is
		86° to 158° F (30° to 70° C) charge the UPS battery every	Do not operate the UPS where there is
		86° to 158° F (30° to 70° C) charge the UPS battery every	excessive dust or the temperature or
		three months	excessive dust or the temperature or
		three months	humidity are outside the specified limits.
			humidity are outside the specified limits.
	Maximum		This unit has front to rear airflow. Allow
	Elevation		adequate space for proper ventilation.
	Operating	10,000 ft (3,000 m)	Environmental factors impact battery life.
	Storage	50,000 ft (15,240 m)	Environmental factors impact battery life.
	Storage	50,000 ft (15,240 m)	High temperatures, poor utility power, and
			High temperatures, poor utility power, and
	Humidity	0 to 95% relative humidity, non-condensing	frequent, short duration discharges will
	Humidity	0 to 95% relative humidity, non-condensing	shorten battery life.
			shorten battery life.

	Physical Specifications

	Weight (unpacked)

	UPS	145 lbs (66 kg)

	XL Battery Pack
	with eight battery	400 lbs (181 kg)
	modules

	Each battery	38 lbs (17 kg)
	module	38 lbs (17 kg)

Maximum Number of XLBPs Supported by the Smart-UPS XL

10

Dimensions
		482 mm
		19 in
		465 mm
		18.3 in
		432 mm	773 mm
		17 in	30.4 in
263 mm 10.4 in	102 mm	4 in

2	Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

Image 6

Contents XLI/XLICH Page Contents Page Unpack package contents About this UPSPhysical Specifications SpecificationsEnvironmental Specifications Maximum Number of XLBPs Supported by the Smart-UPS XLInstallation Stack or rack-mount front panelStack configuration Rack-mount configurationInstall units in rack Install and connect battery modulesRoute ethernet cable and install bezels Accessories Optional accessoriesInstall the wiring trays, refer to graphics below Install input and output wiring trays in UPS rear panel XlbpWiring Specifications Adhere to national and local electrical codes when wiringInput wiring options Input/Output Jumper ConfigurationsSingle phase input, single phase output, single feed Single phase input, single phase output, dual feedThree phase input, single phase output, dual feed Three phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, three phase output, dual feedOutput wiring options L3 L2 L1 OSJSingle phase output connection to battery pack PDU PowerView Interface Display OperationNavigating menu screens Main Menu ScreenMenu Tree Navigating sub menu screensSub menu screens SystemExternal Battery Pack Connect power to UPS and load Connect load to UPSCommunication Ports Emergency Power Off EPO ConnectorTroubleshooting Display Messages Output Jumper Configurations tablePage Refer to Contact Information in this Option 2 Correct bypass input Maintenance, Transport, and Service Replace battery modulesService Two-Year Warranty Terms of warrantyRegulatory Agency Approvals and Radio Frequency Warnings ModelsDate of product declaration