American Power Conversion RT XLI/XLICH Install units in rack, Install and connect battery modules

Page 9

Install units in rack

Secure the UPS and the XLBP in the rack using the cage nuts and ornamental screws included in the package.

Four ornamental screws and two cage

7 holes

nuts must be used to secure each unit.

A cage nut must be used in the top hole of each rack-mount bracket when securing the unit in the rack.

The bottom hole of each rack-mount bracket can be secured using an ornamental screw in the threaded hole.

Install and connect battery modules

Replace the battery doors.

7 holes

4x

4x

Connect all eight battery modules. Failure to do so may cause equipment damage.

Tighten the screws to secure the battery doors.

Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

5

Image 9
Contents XLI/XLICH Page Contents Page About this UPS Unpack package contentsEnvironmental Specifications SpecificationsPhysical Specifications Maximum Number of XLBPs Supported by the Smart-UPS XLStack or rack-mount front panel InstallationRack-mount configuration Stack configurationInstall and connect battery modules Install units in rackRoute ethernet cable and install bezels Optional accessories AccessoriesInstall the wiring trays, refer to graphics below Xlbp Install input and output wiring trays in UPS rear panelAdhere to national and local electrical codes when wiring Wiring SpecificationsInput/Output Jumper Configurations Input wiring optionsSingle phase input, single phase output, dual feed Single phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, single phase output, single feedThree phase input, single phase output, dual feed Three phase input, three phase output, dual feedL3 L2 L1 OSJ Output wiring optionsSingle phase output connection to battery pack PDU Operation PowerView Interface DisplayMain Menu Screen Navigating menu screensNavigating sub menu screens Menu TreeSystem Sub menu screensExternal Battery Pack Connect power to UPS and load Connect load to UPSCommunication Ports Connector Emergency Power Off EPOOutput Jumper Configurations table Troubleshooting Display MessagesPage Refer to Contact Information in this Option 2 Correct bypass input Maintenance, Transport, and Service Replace battery modulesService Terms of warranty Two-Year WarrantyModels Regulatory Agency Approvals and Radio Frequency WarningsDate of product declaration