American Power Conversion RT XLI/XLICH Install the wiring trays, refer to graphics below

Page 12

Hardwire the UPS

Wiring must be performed by a qualified electrician. Adhere to all local and national electrical codes.

1.For input wiring only, install a utility circuit breaker in accordance with local electrical codes.

2.Switch the utility circuit breaker OFF.

3.Remove the appropriate circular knockouts from the input and output wiring trays.

4.Remove the screws that secure the covers and take the covers off of the trays.

5.Remove the five screws that secure the strain relief bar.

Input Wiring Tray

Output Wiring Tray

5x

Strain Relief Bar

6.Remove the appropriate jumpers for input power source compatibility and output wiring options, (refer to the Wiring sections in this manual).

7.Run wires through the knockout holes to the terminal blocks. Wire the ground terminal first, (refer to tables and graphics in the Wiring sections this manual).

8.Use strain-relief (not supplied), on the hardwired input and output power cables.

9.Replace the wiring tray covers. Failure to do so may result in personal injury or equipment damage.

10.Install the wiring trays, (refer to graphics below).

8

Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

Image 12
Contents XLI/XLICH Page Contents Page Unpack package contents About this UPSSpecifications Environmental SpecificationsPhysical Specifications Maximum Number of XLBPs Supported by the Smart-UPS XLInstallation Stack or rack-mount front panelStack configuration Rack-mount configurationInstall units in rack Install and connect battery modulesRoute ethernet cable and install bezels Accessories Optional accessoriesInstall the wiring trays, refer to graphics below Install input and output wiring trays in UPS rear panel XlbpWiring Specifications Adhere to national and local electrical codes when wiringInput wiring options Input/Output Jumper ConfigurationsSingle phase input, single phase output, single feed Single phase input, single phase output, dual feedThree phase input, single phase output, single feed Three phase input, three phase output, single feedThree phase input, single phase output, dual feed Three phase input, three phase output, dual feedOutput wiring options L3 L2 L1 OSJSingle phase output connection to battery pack PDU PowerView Interface Display OperationNavigating menu screens Main Menu ScreenMenu Tree Navigating sub menu screensSub menu screens SystemExternal Battery Pack Connect power to UPS and load Connect load to UPSCommunication Ports Emergency Power Off EPO ConnectorTroubleshooting Display Messages Output Jumper Configurations tablePage Refer to Contact Information in this Option 2 Correct bypass input Maintenance, Transport, and Service Replace battery modulesService Two-Year Warranty Terms of warrantyRegulatory Agency Approvals and Radio Frequency Warnings ModelsDate of product declaration