American Power Conversion RT XLI/XLICH user manual Installation, Stack or rack-mount front panel

Page 7

Installation

Stack or rack-mount front panel

PowerView Interface Display RJ45 Connector (pass through to rear panel RJ45 connector)

Serial Port

PowerView Cable Connector

SmartSlot with Network

Management Card

Ethernet port 10/100 Base-T

Cold Start/EPO Reset

PowerView installation for stack or rack-mount configurations

Prior to attaching the PowerView to the UPS:

1.Loosen the two bracket screws on the back of the PowerView module.

a.Slide the bracket to the position that will accommodate the screw holes on the UPS.

b.Tighten the screws on the bracket.

2.Secure the PowerView to the UPS using the two thumb screws attached to the PowerView.

Connect the PowerView cable to the PowerView connector on the UPS.

Smart-UPS RT 15000/20000 VA 230 Vac Stack/Rack-Mount 6U User Manual

3

Image 7

Contents XLI/XLICH Page Contents Page About this UPS Unpack package contentsMaximum Number of XLBPs Supported by the Smart-UPS XL SpecificationsEnvironmental Specifications Physical SpecificationsStack or rack-mount front panel InstallationRack-mount configuration Stack configurationInstall and connect battery modules Install units in rackRoute ethernet cable and install bezels Optional accessories AccessoriesInstall the wiring trays, refer to graphics below Xlbp Install input and output wiring trays in UPS rear panelAdhere to national and local electrical codes when wiring Wiring SpecificationsInput/Output Jumper Configurations Input wiring optionsSingle phase input, single phase output, dual feed Single phase input, single phase output, single feedThree phase input, three phase output, dual feed Three phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, single phase output, dual feedL3 L2 L1 OSJ Output wiring optionsSingle phase output connection to battery pack PDU Operation PowerView Interface DisplayMain Menu Screen Navigating menu screensNavigating sub menu screens Menu TreeSystem Sub menu screensExternal Battery Pack Connect load to UPS Connect power to UPS and loadCommunication Ports Connector Emergency Power Off EPOOutput Jumper Configurations table Troubleshooting Display MessagesPage Refer to Contact Information in this Option 2 Correct bypass input Replace battery modules Maintenance, Transport, and ServiceService Terms of warranty Two-Year WarrantyModels Regulatory Agency Approvals and Radio Frequency WarningsDate of product declaration