APC 2000XL, 900XL, 600XL user manual Storing the UPS, Storage conditions, Extended storage

Page 37

8.0Storing the UPS

8.1Storage conditions

The UPS should be covered and stored upright in a cool dry location. The UPS should be stored with its Battery packs in a fully charged state. That is, the indicated battery capacity should be 100% before the UPS is switched off for storage. Once charged, disconnect the Battery packs from each other and from the UPS.

8.2 Extended storage

To achieve expected run time following extended storage, the UPS should be allowed to refresh its batteries every 6 months in environments where the ambient temperature is -15°C to +30° C (5° F to 86° F). For extended storage in environments where the ambient temperature is +30° C to +45° C (86° F to 113° F), the UPS should be allowed to refresh its batteries every 3 months.

Page 35

Image 37
Contents Smart-UPS Radio Frequency Interference Important safety instructionsTable of contents Overview IntroductionSmartBoost Battery replacement indicators and testRemote interfaces Extended capabilitiesEnglish SafetySécurité Deutsch Sicherheit¡ Seguridad 600VA and 900VA models 120 Vac version PresentationFront view Rear view 600VA and 900VA models 220/230/240 Vac version 2000VA model 120 Vac version Option 2000VA model 120 Vac version optionsFront view 2000VA model 220/230/240 Vac versionPlacement InstallationInstall bracket 2000VA models, 220/230/240 Vac version Receiving inspectionConnect battery pack Connect UPS to service Connect UPS to service and enableEnable UPS Switch on load equipment Check Site Wiring Fault indicator 120 Vac versionsSwitch on the UPS Plug loads into UPSOperation Display featuresOutput power bar graph Battery capacity bar graphOn-battery operation Audible alarmLow battery Line voltage bar graphReplace battery Option switchesOption switch OverloadOperation Monitoring Status reportingOperation customizing Power managementOperation UPS Monitoring PowerChute SoftwareInterface Kits Computer interface port Difficulty Difficulté Schwierigkeit Dificultad Troubleshooting chart FheNbRc FeiiVNbR OMliR MOkVed ke kMaR Battery replacement check Obtaining Service Storage conditions Storing the UPSExtended storage Transfer characteristics SpecificationsOutput characteristics InputNoise and surge suppression Battery and chargerEnvironment Physical1 600VA, 900VA models Typical recharge time and run time versus load+ 3.6 hr 2 2000VA modelsDeclaration of Conformity Life support policy Limited Warranty∗ Mailing