Orion Car Audio CO3002, CO6002 owner manual Output Plate

Page 5

without signal.

3.RCA Inputs - Accepts RCA input from a source unit, preamplifier, or equalizer.

4.Gain Control - Continuously adjusts from 175mV to 8V input to obtain full power output.

5.HPF, FULL, LPF Switch - Selects either Hi-pass crossover, Full range, or Lo-pass cross- over.

6.Lo-Pass Frequency Control - Adjusts the frequency of the crossover.

7.Hi-Pass Frequency Control - Adjusts the frequency of the crossover.

8.Bass Boost Switch - Adjusts bass gain in three steps (0dB, 6dB, & 12dB).

9.Status LED - Will indicate any fault condition in amplifier, also lights briefly during muting phase of turn-on

Output Plate

CO3002

Figure 3

Figura 3

Abbildung 3

Figure 4

Figura 4

Abbildung 4

1

2

3

4

5

CO6002

1

2

2

3

4

5

1.Speaker Connections - accepts up to 12 AWG speaker wire.

2.1 ATC Fuse (CO3002) - 2 ATC Fuses (CO6002) - protects the amplifier from over current situations.

3.Power Connections - accepts up to 4 AWG power cables.

4.REM Remote Turn-on Input - turns on the amplifier when fed 12 V+.

5.Ground Connection - accepts up to 4 AWG ground cable.

4

© 2008 directed electronics—all rights reserved

Image 5
Contents Amplifier Table of Contents Practice Safe Sound IntroductionWHAT’S in the BOX Input Plate Tools of the TradeEND Panel Layouts Output Plate Amplifier Settings CEA SpecificationsSignal Input and Output Configurations High Level HarnessesAmplifier Wiring Tri-mode Amplifier InstallationBridging Choosing Mounting LocationsStep By Step Installation General Precautions and Installation TipsPassenger Compartment Trunk CompartmentTesting the System SET UP and TroubleshootingAdjusting the Sound of the System Symptom Probable Cause Action To Take Troubleshooting TipsSymptom Probable Cause Action To Take Crossover Section SpecificationsAmplifier Section CO3002 CO6002 Directed electronics-all rights reserved Agencement DES Panneaux Dextrémité FrançaisSpécifications DE Lace Configurations dentrée et sortie du signalFaisceaux À Haut Niveau Réglages DE LamplificateurCâblage DE Lamplificateur Installation DE Lamplificateur Installation étape par étape Réglage sonore du système Réglage ET DépannageEssai du système Directed electronics-all rights reserved Symptôme Cause probable Faire Conseils de dépannageDirected electronics-all rights reserved Section répartiteur SpécificationsSection amplificateur CO3002 CO6002 Disposiciones DEL Panel DE Extremo EspañolConfiguraciones de salida y entrada de señal Configuraciones DEL AmplificadorEspecificaciones DE LA CEA Arneses DE Cableado DE Alto NivelCableado DEL Amplificador Instalación DEL Amplificador Instalación paso a paso Ajuste de sonido del sistema Configuración Y Detección Y Reparación DE AveríasPrueba del sistema Directed electronics-all rights reserved Síntoma Causa probable Medidas a tomar Sugerencias de detección y reparación de averíasDirected electronics-all rights reserved Sección de crossover EspecificacionesSección de amplificador CO3002 CO6002 Layouts DER Endabdeckung DeutschCEA-DATEN Signaleingangs- und -ausgangskonfigurationenHOCHPEGEL-LEITUNGSSYSTEME VerstärkereinstellungenVerstärkeranschluss Verstärkerinstallation Schrittweise Installation Systemsound einstellen Einrichtung UND ProblembehebungSystemtest Directed electronics-all rights reserved Symptom Mögliche Ursache Lösung ProblemlösungenDirected electronics-all rights reserved Crossover-Bereich DatenVerstärkerbereich CO3002 CO6002 Layout DEI Pannelli Terminali ItalianoSpecifiche CEA Configurazione dei segnali d’ingresso e di uscitaCavi DI Livello Alto Impostazioni DELL’AMPLIFICATORECrossover interni Cablaggio DELL’AMPLIFICATORECrossover passa-basso Crossover passa-altoInstallazione DELL’AMPLIFICATORE Procedura di installazione Regolazione dell’audio dell’impianto Messa a Punto E Soluzione DEI ProblemiProva dell’impianto Directed electronics-all rights reserved Sintomo Causa probabile Intervento necessario Soluzione dei problemiDirected electronics-all rights reserved Sezione crossover Dati TecniciSezione amplificatore CO3002 CO6002 Layouts DOS Painéis PortuguêsEspecificações DA CEA Configurações de entrada e saída dos sinaisLigações DE Alto Nível Ajustes do AmplificadorConexão DOS Cabos do Amplificador Instalação do Amplificador Instalação passo a passo Como ajustar o som do sistema Instalação E Resolução DE ProblemasComo testar o sistema Directed electronics-all rights reserved Problema Provável causa Medida a ser tomada Sugestões para resolução de problemasDirected electronics-all rights reserved Seção do crossover EspecificaçõesSeção do amplificador CO3002 CO6002 Warranty