Internal Crossover
The crossover section of the Orion Cobalt CO3002 and CO6002 amplifiers is continuously variable and extremely flexible.
When using Orion Cobalt loudspeakers, minor deviations from the recommended frequency ranges can provide superior results depending on your speaker locations and your vehicle acoustics. Setting crossover frequencies higher than recommended will not cause damage and may provide superior sonic results depending on your system's performance goals. Refer to your loudspeaker owner's manual for assistance in choosing the proper crossover frequencies for your system.
Low-Pass Crossover
The
High-Pass Crossover
When the switch is to the left (FULL position), the
AMPLIFIER WIRING
Power Connections for the Orion Cobalt CO3002 and CO6002
●Orion Cobalt CO3002 Fuse Size: 1 x 25 AMP ATC / CO6002 Fuse Size: 2 x 20 AMP ATC
●Power connections accept up to 4 AWG wire.
●4 AWG power and ground wire recommended for optimal performance.
●Connect 12V+ to the battery through fuse holder. This connection provides +12V main power to the amplifier.
●Power wire must be fused no more than 18" from battery.
●Ground amplifier to a good chassis ground as close as possible to the amplifier.
●Connect REM terminal to remote
●Add extra ground wire between the negative terminal of the battery and the chassis.
Speaker Wiring Diagram CO3002/CO6002
The Orion Cobalt CO3002 and CO6002 amplifiers offer two positive and two negative output termi- nals for ease of connecting the speakers to the amplifier. Each amplifier is stable to 2Ω per channel or 4 ohm bridged .
Figure 5
Figura 5
Abbildung 5
Bridged
- | + | - | + |
4Ω or 8Ω
| Stereo |
| |
- | + | - | + |
2Ω or 4Ω |
|
| |
2Ω or 4Ω |
|
| |
6 | © 2008 directed |