5.The self-test automatically ends after printing "*** completed ***". The printer is ready to receive data from the computer after the self-test completes.
6.Self-test mode switches to normal mode.
Running the self-test with validation paper
Qa, Note:Be sure to install the paper roll in the printer to prevent validation paper jams.
1.Make sure the printer is turned off and the printer cover is closed properly.
2.Hold down the PAPER FEED and RELEASE buttons and turn on the printer to begin the self-test. The VALIDATION/SLIP light flashes.
3.Feed a sheet of validation paper into the printer. The self-test prints the printer settings, and then ejects the paper. The VALIDATION/SLIP light flashes.
4.Remove the paper and feed another sheet of validation paper into the printer to print characters from the character table. Continue to feed
validation paper into the printer until the self-test prints "*** completed
***".
5.The self-test automatically ends after printing "*** completed ***". The printer is ready to receive data from the computer after the self-test completes.
6.Self-test mode switches to normal mode.
,Note:
%If you want to pause the self-test for the paper roll, slip paper, or validation paper at any point, press the PAPER FEED button. Press the PAPER FEED button again to resume the self-test.
Setting Up the Printer 1-19