Epson TM-U375 user manual Adjusting the Paper Roll End Sensing Position

Page 33

%h, Note:

To attach the DIP switch cover, insert the cover upward then slide the cover leftward, as shown in the illustration below.

Adjusting the Paper Roll End Sensing Position

The paper near end detector detects when the paper is almost gone by measuring the diameter of the paper roll. Software programs can use the ESC c 4 command to stop printing when the paper is almost gone.

If you want to change the amount of paper remaining when the printer stops printing, follow the steps below to adjust the paper near end detector.

,Note:

%If the inner diameter of the paper roll core is less than 10 mm (0.39 inch), the paper roll near-end detector may not work properly.

1.Open the printer cover and remove the take-up spool.

2.Determine the point on the paper roll at which you want the near-end detector to be triggered. Then measure the distance A shown in the illustration.

Setting Up the Printer 1-23

Image 33
Contents TM-U375 Control Panel Printer Part NamesPage EMC and Safety Standards Applied CE Marking Gereäuschpegel About This Manual Setting up and Using FeaturesReference Contents Reference Information TroubleshootingSetting Up the Printer Removing the Protective Materials UnpackingProtective material Remove the protective materials C as the illustration Connecting the Printer to Your Computer TM-U375TM-U375P Connecting the Printer to Your Drawer TM-U375 TM-U375P Anschließen des Druckers an lhre Geldlade AchtungAchtung TM-U375 Grounding the Printer Connecting the Power Supply Plug the power supply’s power cord into an electrical outlet Installing the Ribbon Cassette Setting Up the Printer 1 1 Installing the Paper Roll Paper inlet Paper Load switch Running the Self-test Running the self-test with paper rollRunning the self-test with the slip paper Running the self-test with validation paper Setting the DIP Switches DIP Switch Set TM-U375 DIP-switch functions42CPL/35CPL 40CPL/33CPL TM-U375P DIP-switch functionsAdjusting the Paper Roll End Sensing Position Distance a Adjustment position number Using the Power Switch Cover Using the Printer Operating the Control Panel ButtonsLndicator lights Page Validation Paper Handling Slip Paper HandlingReplacing the Paper Roll Replacing the Ribbon Cassette Qsh Removing the ribbon cassetteOr 3 times Print head Troubleshooting Printing problems General problemsError light is off but nothing is printed Page Release lever Left side of the printer Starting hexadecimal dumping Hexadecimal DumpingEnding hexadecimal dumping Reference Information Character Specifications Printing SpecificationsPaper Paper SpecificationsNumber of Copies Ambient Temperature Glue Location of Slip paper Page Humidity Environmental SpecificationsPrinting on Cut Sheets Interface SpecificationsPage Example print control for cut sheet Transmit Status Identification 12 c