Quick Start Guide
Media Loading
Loading and Feeding Label Roll
Figure 3 outlines the media path for loading the label stock.
Printhead |
| Label Roll |
Lock Lever |
| Shaft |
| Printhead |
| Label Guide Bar |
|
| Bracket |
|
|
|
|
| |||
|
|
|
|
|
Label Guide |
|
|
| |
| Guide Block | |||
Blocks |
| |||
| Adjustment Knob | |||
|
|
| ||
|
|
|
|
|
Figure 3 – Label Roll Feed Path
1.Lift the Media Access Cover using the tab in the bottom center side of the cover. DO NOT lift from the front panel.
2.Find the “PRESS HERE” label affixed to the Printhead Bracket. Press down on the Printhead Bracket where indicated and rotate the Printhead Lock Lever back to unlock the bracket. Swing the Printhead Bracket up and back to expose the document path.
3.Before mounting the roll of labels on the Label Roll Shaft, run the end of the new label roll between the Label Guide Blocks, under the Printhead Bracket, out beyond the front of the printer. The labels must be facing up when going underneath the printhead. Refer to Figure 3 for the proper label path.
4.Using the Guide Block Adjustment Knob adjust the width of the Label Guide Blocks. The label material should come close to touching the inner edge of the guide block, yet move freely without bowing the label.
5.Return the Printhead Bracket to its original position and rotate the Printhead Lock Lever to lock the bracket into place.
6.Place the roll on the Label Roll Shaft and center it on the shaft. The blades will hold the label roll in place.
9