AMT Datasouth 7200 manual Connecting the ATB Printer, Connecting to a Wall Receptacle

Page 21

7200

2.1 Connecting the ATB Printer

This section explains how to connect the ATB printer to the power supply and the terminal.

2.1.1Connecting to a Wall Receptacle

A.Check that the power switch on the ATB printer is turned off.

Ferrite Core

B.Plug the power cable into the ATB printer. Then, plug the other end of the power cable into a wall receptacle.

Note!

Only use the supplied power cable. Ensure that the power cord complies with all local ordinances.

IMPORTANT...

The Ferrite Core must be attached to the AC Power Cord before the printer is connected to the wall receptacle. Failure to attach the Ferrite Core to the AC Power Cord may cause non-compli- ance to:

FCC Regulations for Class A computing device	Canadian ICES-003
EN55022-1 Class A Limits	EN50082-1
EN61000-3-2	EN61000-3-3

2-2	Operation Manual

Image 21

Contents 7200 Contents Is intentionally blank Introduction FCC Warning Product Safety Safety Considerations Location Operating EnvironmentSpace Required Connecting to Power Power Line ConditionsType Printing Method Number of Bins Available TypesViii Before Using the ATB Printer Checking the Package Names of Parts Names and FunctionsNames Functions FunctionsLED Functions Operator PanelLCD Panel Functions Operator Panel LayoutOnline Key FunctionsTest 7200 Operation Connecting to a Wall Receptacle Connecting the ATB PrinterConnecting the Terminal CHECK-IN Ticketing Turning the Power On and OffLoading the Documents Loading Documents into BINs 1Key cannot be removed in the Open position Document Orientation Visual 7200 Setting Documents in BIN Keep space for the documentsDo not remove the documents from the box Key cannot be removed Open position Close the side cover top right 7200 Loading Documents into the Inserter Installing the Transfer Ribbon TT Type D Only Pivots Lock Operation Changing Transfer Ribbons TT Type D Only LCD Panel DisplayFollowing operation is only for thermal transfer Treat used transfer ribbons as plastic waste 7200 Daily Maintenance Cleaning the Printer Surface Cleaning the ATB PrinterCleaning card is optional sold separately Cleaning the Magnetic HeadRepeat the cleaning procedure several times as necessary Cleaning the Thermal Head Cleaning a Platen Roller Inserter and Magnetic Blocks Cleaning a Carrier RollerBin and Cutter Blocks To Clean BINRemoving Paper Dust 7200 Troubleshooting Paper Jam Part NamesJam Locations and Corresponding Messages Jam Position Removing Procedures Unlock the cover before starting any procedureRemoving the jammed coupon For a jam in BIN For a jam in BIN 3 Option After the jammed coupon has been cut If the jammed coupon has not been cut Side pressure roller Method varies depending on the location of the jammed coupon To remove the jammed coupon, go to step E Rear end of the jammed ticket is on the blade Troubleshooting Error Message Error State Recovery Procedure Error MessagesTroubleshooting L O G I C a L Error M e s s a g e Error State Recovery Procedure 7200 Appendix 1 Specifications Document Carrier StructureDocument Carrier Structure Side Covers Open/Closed CoversPower Connection Temperature and HumidityPower Line Conditions Connecting to PowerEncoding Specifications Bins and FeederPrinting Inserter Output StackerTransfer Ribbon Printing Type D printers only Appendix 2 Consumables Printer AccessoriesThermal Transfer Ribbon StoringTransfer RibbonsAMT Datasouth Corp