AMT Datasouth 7200 manual Turning the Power On and Off, CHECK-IN Ticketing

Page 23

7200

2.2 Turning the Power On and Off

After the ATB printer has been successfully installed and connected, turn on the power.

Note!

Turn on the terminal before turning on the ATB printer. Reverse the sequence when turning off the power.

Turn the power switch on.

The LCD panel displays the following three indicators in turn for specified intervals (a few seconds). Then, the ATB printer is set online.

When the power is turned on, the four LEDs are turned on as part of the self test routine.

ONLINE (OFF)

ONLINE

(ON)

S7200/PC94.03.08

S7200/08.30 Mecha.Type: D

CHECK-IN

or

TICKETING

LCD Test

ROM Version

(The display on the left is an example.)

Available Type

(The display on the left is an example.)

Modes

(The display on the left is an example.)

The ATB printer is checking itself.

This indicates the online status.

(Ticketing is enabled.)

The above is only an example. The actual displayed ROM value and available type

may be different from this example.

2-4	Operation Manual

Image 23

Contents 7200 Contents Is intentionally blank Introduction FCC Warning Product Safety Safety Considerations Location Operating EnvironmentSpace Required Connecting to Power Power Line ConditionsType Printing Method Number of Bins Available TypesViii Before Using the ATB Printer Checking the Package Names of Parts Names and FunctionsNames Functions FunctionsOperator Panel Layout Operator PanelLED Functions LCD Panel FunctionsOnline Key FunctionsTest 7200 Operation Connecting to a Wall Receptacle Connecting the ATB PrinterConnecting the Terminal CHECK-IN Ticketing Turning the Power On and OffKey cannot be removed in the Open position Loading the DocumentsLoading Documents into BINs 1 Document Orientation Visual 7200 Do not remove the documents from the box Setting Documents in BINKeep space for the documents Key cannot be removed Open position Close the side cover top right 7200 Loading Documents into the Inserter Installing the Transfer Ribbon TT Type D Only Pivots Lock Operation Following operation is only for thermal transfer Changing Transfer Ribbons TT Type D OnlyLCD Panel Display Treat used transfer ribbons as plastic waste 7200 Daily Maintenance Cleaning the Printer Surface Cleaning the ATB PrinterCleaning card is optional sold separately Cleaning the Magnetic HeadRepeat the cleaning procedure several times as necessary Cleaning the Thermal Head Cleaning a Platen Roller Inserter and Magnetic Blocks Cleaning a Carrier RollerBin and Cutter Blocks To Clean BINRemoving Paper Dust 7200 Troubleshooting Jam Locations and Corresponding Messages Paper JamPart Names Removing the jammed coupon Jam Position Removing ProceduresUnlock the cover before starting any procedure For a jam in BIN For a jam in BIN 3 Option After the jammed coupon has been cut If the jammed coupon has not been cut Side pressure roller Method varies depending on the location of the jammed coupon To remove the jammed coupon, go to step E Rear end of the jammed ticket is on the blade Troubleshooting Error Message Error State Recovery Procedure Error MessagesTroubleshooting L O G I C a L Error M e s s a g e Error State Recovery Procedure 7200 Document Carrier Structure Appendix 1 SpecificationsDocument Carrier Structure Side Covers Open/Closed CoversConnecting to Power Temperature and HumidityPower Connection Power Line ConditionsPrinting Encoding SpecificationsBins and Feeder Transfer Ribbon Printing Type D printers only InserterOutput Stacker StoringTransfer Ribbons Printer AccessoriesAppendix 2 Consumables Thermal Transfer RibbonAMT Datasouth Corp