Siemens 2614 manual Configuring Printer Services, Install the Print Server Program

Page 29

CHAPTER 5

CONFIGURING PRINTER SERVICES

The SpeedStream 2614 printer server supports Windows 95/98/NT/2000/ME and Unix platforms. To configure print services for devices attached to the SpeedStream 2614:

1.Install the print server program from the SpeedStream 2614 CD-ROM.

2.Configure the SpeedStream 2614 printer port for your operating system.

Install the Print Server Program

1.Insert the installation CD into your CD-ROM drive. If autorun is enabled on your system, the installation program will begin automatically. If not, double-click setup.exe on the the CD to manually start the program.

Figure 5-1. Printer Server Setup Program

2.Close any open Windows programs; then click Next on the Welcome screen.

3.On the Choose Destination Location screen, accept the default folder location or click Browse to navigate to a new location; then click Next. The setup program will install the programs in the

5-1

Image 29

Contents 2614 Table of Contents Appendixes About the SpeedStream Features and BenefitsIntroduction Applications Description of Hardware Installing the SpeedstreamPackage Contents SpeedStream Installation Procedure Hardware InstallationSystem Requirements Before StartingConnecting the SpeedStream LED Status Indicators Page Navigating the Management Interface Configuring the SpeedstreamWeb Browser Management Interface Menu Item Description Menu SelectionsView Network and Device Status Configuration ChangesOn the Tools menu, click Internet Options General box, select Temporary Internet FilesSet or Change a Password Simple Setup ProceduresOn the Simple Setup menu, click Change Password Set the Time ZoneOn the Simple Setup menu, click Set Time Zone Configure the WAN ConnectionStatic IP Address Fixed IP Fill in the relevant fields under Secondary Dial-up Configure LAN Gateway and Dhcp Settings Advanced Setup ProceduresEnable Virtual Server Enable Firewall ProtectionNetwork Address Translation NAT Configure Special ApplicationsConfigure Client Filtering Configure Miscellaneous FeaturesSystem Tools On the Tools menu, click Change PasswordRestore Factory Defaults Reset RouterUpdate Firmware Backup SettingsClick Start/Settings then click Control Panel Installing and Configuring TCP/IPInstall the TCP/IP Protocol Dynamic IP Allocation via a Dhcp Server Configure TCP/IP for the SpeedStreamTCP/IP Verification Manual IP ConfigurationIs TCP/IP properly configured on your computer? Install the Print Server Program Configuring Printer ServicesSpecified location Select Port Name Windows 95/98/NT/ME Configure the Printer PortSelect Printer Port WindowsSelect Local printer then click Next 11. Select Printer Port Unix SystemsAppendix a TroubleshootingTechnical Support Appendix B Cable Types and SpecificationsCables Ethernet CableRJ-45 Pin Numbering RJ-45 Pin AssignmentsSerial Port Pin Assignments Serial Port to 25-Pin DCE Port on Modem DB-9 Port Pin AssignmentsSerial Port to 9-Pin COM Port on Computer Serial Port to 25-Pin DTE Port on Computer Printer Port Pin AssignmentsDB-25 Printer Port Pin Assignments Pin Signal Name DirectionSpecifications Temperature